2. Neptune
  3. CoR

Neptune CoR Mounting Template

  • I've reviewed the provided mounting template for the COR module from Neptune Systems. This document outlines the necessary steps to properly mount the module, ensuring adequate spacing for cables and screw placement. I'm ready to assist with any questions you may have regarding the installation process described in the document.
  • What is the minimum space needed above the module?
    What is the minimum space needed below the module for cables?
    Do I need to drill pilot holes?
    What printing options should I avoid?
Set your printer properties to print actual
size. Print To Fit or Scaled printing
options must not be used.
Use scissors to cut trim the printout if
desired. Position the template where
desired, then mark the 2 screw holes with
a sharp pointed object. Drilling of a pilot
hole is recommended.
Mark for screws hereMark for screws here
Allow at least 3/4"(20mm) above
Allow at least 2.5" (65mm)
below the module for cables
/