Ohlins 01588-02 Mounting Instruction

Type
Mounting Instruction
Öhlins Racing AB
Box 722
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00
fax +46 8 590 025 80
© Öhlins Racing AB. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
www.ohlins.com
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updates
may occur.
To nd the latest information
contact an Öhlins distributor.
Please contact Öhlins if you have
any questions regarding the
contents in this document.
Fully Engaged Top Out Spring Kit
01588-02 for FGR 200
Mounting Instructions
Before installing this product, check the contents
of the kit. If anything is missing, please contact
an Öhlins dealer.
Kit Contents
Part No Pcs
TOS spring-kit 01588-02 1
Set-up Data
Part no. 01588-02
Issued 2012-01-19
Warning!
Before riding, always make sure that the
basic settings made by Öhlins are according
to recommended Set-up Data. Read about
adjustments and setting up in the Öhlins
Owner’s Manual before you make any
adjustments. Contact an Öhlins dealer if you
have any questions about setting up.
Warning!
This kit should only be installed by an
authorized Öhlins dealer. The installation
procedure requires certain tools.
Before installing this product, read this
document and the Owner’s Manual. The
front fork is an important part of your vehicle
and will affect the stability.
1
Install Öhlins Top Out Spring Kit
Warning!
It is advisable to have an Öhlins dealer install
this top out spring kit, always consult your
Owners manual when working on your fork.
1
Disassemble shaft according to Chapter 5.1 to
5.4 in the Owners Manual.
2
Remove spacer (01582-24) and the original
spring (21733-01).
3
Mount the spring-kit between the upper sleeve
(01653-09) and the piston (02061-07).
4
Tighten the Piston. Use a 20 mm wrench and
Loctite 243, Tightening torque 10 Nm.
5
Assemble front fork according to Chapter 6 in
Owner’s Manual.
2
3 4
1
2
  • Page 1 1
  • Page 2 2

Ohlins 01588-02 Mounting Instruction

Type
Mounting Instruction

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI