4
5
1.
LED3
LED2
LED1
3.
4.
5.
6.
7.
1. Power LED
2. Three LEDs Indicators for pairing, active/stand-by, low
battery (2-1: LED1 / 2-2: LED2 / 2-3: LED3)
3. Microphone
4. Volume Control
5. Multi-function Button (power on, pairing, active,
stand-by)
6. Charging Socket
7. Speaker
Status Indicators
1) Power LED – Power on mode
2) LED 1 -> Connecting Status
Stand by Mode: two times blinking every two
second
Pairing Mode: blinking continuously.
Active Mode: Power on continuously
3) LED 2 -> Call Activity Status
Sending and Receiving Phone Call:
Blinking shortly
Active call : Lit continuously
4) LED 3 -> Low battery Status:
LED blinking continuously
2. Charging your hands-free
Use the vehicle power charger provided.
Lunar uses a rechargeable battery that must be fully charg-
ed before you use it for the fi rst time. Connect the supplied
vehicle power charger to power socket and then to your
Hands-Free. The status of indicator on Vehicle charger
will be illu-minated red while charging and change to
Green when the Hands-Free is fully charged. It takes
approximately 2 hours to fully charge the Hands-free.
Notice: If battery is Low, Red light of the LED 3 will blink
in every second. This LED does not light up during the
charging procedure.
3. Bluetooth Pairing
• Turn on both devices.
• For Hands-free, press the multifunction button for two
seconds.
1) Place the Hands-free in pairing mode by pressing and
holding the volume down Button for fi ve seconds.
Release the button when the status indicator begin to
fast fl ash with beep sound.
Notice: If the pairing is not success for two minutes, the
Hands–free becomes to stands-by mode.
2) Use your phone’s menu to search for Bluetooth audio
devices and select “BHF-200”
3) When the phone display asks for a pass key,
enter“0000”.The Bluetooth icon appears on the display,
once the hands-free successfully paired. If the Hands
free stops responding to button presses, you must reset
the Hands-free.
4. Using your hands-free
1) Power On / Off
• Press the multifunction buttons for two seconds in order
to turn of the device.
g
Operating Instruction
• Press the multifunction buttons for fi ve seconds in order
to turn off the device.
2) Connect the Hands-free to the phone
When disconnected, the Hands-free can be re-connected
to the phone by simply short pressing the multifunction
button.
3) Disconnect the Hands-free from the phone
• Press the volume up /down button simultaneously for a
second.
• It is only possible while there is no on going call
4) Answer / End / Place a call
• To answer a call, short press the multifunction button.
• To end a call, long press the multifunction button for two
seconds.
• If you are on a calling using your phone handset, you can
transfer the call to your Hands-free by two times press of
the multifunction button.
5) Call transfer back to phone
To transfer a call from your Hands-free back to your phone,
two times press of the Multifunction button.
6) Call reject
To reject an incoming call without answering when the
Hands-free is ringing, long press the multifunction button.
7) Last number redial
To redial the last number, two times press the multifunction
button.
8) Volume Up / Down
• Press the volume up / down button to adjust the volume
• During a call, press the Volume Control Buttons to adjust
the volume.
9) Mute / Un-mute
Press the volume up and down button simultaneously.
10) Auto Power Off
The power is turned off automatically when the hands-free
does not work for one hour.
5. Reset hands-free
To clean »Lunar« stick a pin into the hole on the back side