Taurus Alpatec MG 15 DIGITAL Owner's manual

Page is loading ...

English

Ice Maker

MG 15 DIGITAL

Dear customer,

Many thanks for choosing to purchase a TAURUS

ALPATEC brand product.

Thanks to its technology, design and operation

and the fact that it exceeds the strictest quality

standards, a fully satisfactory use and long pro-

duct life can be assured.

- Read these instructions carefully before swit-

ching on the appliance and keep them for future

reference. Failure to follow and observe these

instructions could lead to an accident.

- Clean all the parts of the product that will be in

contact with food, as indicated in the cleaning

section, before use.

SAFETY ADVICE AND WAR-

NINGS

- This appliance can be used by

children aged from 8 years and

above and persons with redu-

ced physical, sensory or mental

capabilities or lack of expe-

rience and knowledge if they

have been given supervision or

instruction concerning use of

the appliance in a safe way and

understand the hazards invol-

ved.

- This appliance is not a toy.

Children should be supervised

to ensure that they do not play

with the appliance.

- Cleaning and user maintenance

shall not be made by children

unless they are supervised.

- Do not store explosive substan-

ces such as aerosol cans with

a ammable propellant in this

appliance.

- This appliance is only for do-

mestic use, not for industrial

or professional use. It is not

intended to be used by guests

in hospitality environments such

as bed and breakfast, hotels,

motels, and other types of

residential environments, even

in farm houses, areas of the kit-

chen staff in shops, ofces and

other work environments.

- If the connection to the mains

has been damaged, it must be

replaced, take the appliance to

an authorised technical sup-

port service. Do not attempt

to disassemble or repair the

appliance by yourself in order to

avoid a hazard.

- WARNING: ll with potable

water only.

- WARNING: Keep ventilation

openings, in the appliance en-

closure or in the built-in structu-

re, clear of obstruction.

- WARNING: Do not use mecha-

nical devices or other means to

accelerate the defrosting pro-

cess, other than those recom-

mended by the manufacturer.

- WARNING: Do not damage the

refrigerant circuit.

- Ensure that the voltage indicated on the rating

label matches the mains voltage before plug-

ging in the appliance.

- Connect the appliance to a base with an earth

socket withstanding a minimum of 16 amperes.

- The appliance’s plug must t into the mains

socket properly. Do not alter the plug. Do not

use plug adaptors.

- Do not force the power cord. Never use the power

cord to lift up, carry or unplug the appliance.

- Do not wrap the power cord around the appliance.

- Do not clip or crease the power cord.

- Do not allow the power cord to come into con-

tact with the appliance’s hot surfaces.

- Do not allow the power cord to hang or to

come into contact with the hot surfaces of the

appliance.

- Check the state of the power cord. Damaged

or tangled cables increase the risk of electric

shock.

- Do not touch the plug with wet hands.

- Do not use the appliance if the cable or plug is

damaged.

- If any of the appliance casings breaks, immedia-

tely disconnect the appliance from the mains to

prevent the possibility of an electric shock.

- Do not use the appliance if it has fallen on the

oor, if there are visible signs of damage or if it

has a leak.

- Do not place the appliance on hot surfaces,

such as cooking plates, gas burners, ovens or

similar.

- Do not place the appliance where it can reach

the sunlight.

- Place the appliance on a horizontal, at, stable

surface and away from other heat sources and

contact with water.

- Do not use or store the appliance outdoors.

- Do not leave the appliance out in the rain or

exposed to moisture. If water gets into the

appliance, this will increase the risk of electric

shock.

- The temperature of the accessible surfaces may

be high when the appliance is in use.

USE AND CARE:

- Fully unroll the appliance’s power cable before

each use.

- Do not use the appliance if its accessories are

not properly tted.

- Do not switch the appliance on without water.

- Do not use the appliance if the on/off switch

does not work.

- Do not move the appliance while in use.

- Do not use the appliance if it is tipped up and do

not turn it over.

- Respect the MAX and MIN levels.

- After its use, disconnect the appliance; do not

trust the container’s detector.

- Disconnect the appliance from the mains when not

in use and before undertaking any cleaning task.

- Unplug the appliance from the mains before

relling the water tank.

- This appliance is for household use only, not

professional, industrial use.

- Store this appliance out of reach of children and/

or persons with physical, sensory or reduced

mental or lack of experience and knowledge.

- Only use water with the appliance.

- The use of bottled mineral water adapted for

human consumption is recommended.

- Never leave the appliance connected and unat-

tended if is not in use. This saves energy and

prolongs the life of the appliance.

- If for any reason the appliance is on re, imme-

diately disconnect it from the mains, ensure the-

re is no presence of air currents that could stoke

the re and put out the ames with the help of a

lid, or other nonammable items, NEVER using

water.

SERVICE:

- Any misuse or failure to follow the instruc-

tions for use renders the guarantee and the

manufacturer’s liability null and void.

DESCRIPTION

A Control panel

B Ice basket

C Water tank

D Compressor

E Drain pipe

F Plug and power cord

G ON/OFF switch

1 ON button

2 OFF button

3 Tank empty indicator

4 Tray full indicator

5 Ice making indicator

6 Time button

7 Timer button

8 Time indicator

INSTALLATION

- Make sure you have removed all packing

material. In order to prevent possible risk of

accidents, do not leave items such as plastic

bags, polystyrene or cables within the reach of

children.

- During transportation, the tilt angle of the

appliance must not exceed 45 °. Do not locate

the appliance upside down as this may damage

the compressor.

- Do not remove the appliance’s support legs

- Place the appliance on a at, stable surface and

away from any heat source.

- The appliance requires proper ventilation in

order to operate correctly. Leave a free space of

15 cm around the appliance.

- Do not obstruct the opening of the door of the

appliance.

- The socket should be easily accessible in order

to be able to quickly disconnect the appliance in

case of an emergency.

INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products’ packaging has been

removed.

- Before using the product for the rst time, clean

the parts that will come into contact with food in

the manner described in the cleaning section.

- It is recommended that you wait for a minimum

of 2 hours after having installed the appliance

before you use it for the rst time, leaving the

front cover open.

- Prepare the appliance according to the function

you wish to use:

FILLING WITH WATER:

- You must ll the water compartment before

turning on the appliance.

- Extract the receptacle from its place.

- Fill the compartment with cold water.

- Fill the receptacle taking care to observe the

MAX and MIN level.

- Put the container back onto its place.

USE:

- Ensure that the electronic connector is properly

attached to the appliance.

- Fill the appliance with water observing the maxi-

mum level. Do not place any liquid other than

drinking water in the tank.

- Connect the appliance to the mains.

- Turn the appliance on, by using the on/off switch

(G).

- Turn the appliance on, by using the on button (1).

- The processing time is approximately 7-12

minutes (depending on water temperature and

room temperature). Caution: The ice cubes

produced may be small and irregular during the

rst 3 cycles.

- Once the ice cubes have been processed, the

excess water will drain into the water tank and

the cubes will fall onto the ice tray (B).

- Caution: the cubes may not be fully transpa-

rent, due to the air entering during processing

development but this does not alter the quality

of the cubes.

- When the water tank is empty, the «Tank emp-

ty» light (4) will light up in white and a beep will

sound for a few seconds.

- Turn off the appliance.

- Fill tank while observing the maximum level.

- Wait 3 minutes before running the appliance again.

- When the ice cube tray is full, the «Tray full»

light (3) will light up and several beeps will

sound.

- Drain the ice cube tray with the help of the

spoon supplied with the appliance.

- Never leave the ice tray full while the appliance

is in use.

- To completely empty the water tank, open the

drain plug (E) located inside the tank, ensuring

that there is a container underneath the applian-

ce. Once the tank is emptied, replace the plug

(E) in the tank.

SETTING THE TIME

- Press the Time button (6) to set the device time

- Press Press to reach the desired time

- Press the Time button to set the minutes of thE

device

- Press SET to reach the desired minutes

TIMER FUNCTION

- Press the timer function button to set the on / off

time as desired.

ONCE YOU HAVE FINISHED USING THE

APPLIANCE:

- After use, press the stop button to turn off the

appliance.

- Turn the appliance off, using the on/off switch.

- Unplug the appliance from the mains.

- Remove the water from the inside of the appliance.

- Drain and dry the water tank before storing the

appliance if you are not going to use it for an

extended period of time.

- Clean the appliance.

SAFETY THERMAL PROTECTOR:

- The appliance has a safety device, which pro-

tects the appliance from overheating.

- If the appliance turns itself off and does not

switch itself on again, disconnect it from the

mains supply, and wait for approximately 15

minutes before reconnecting. If the machine

does not start again seek authorised technical

assistance.

CLEANING

- Disconnect the appliance from the mains and allow

it to cool before undertaking any cleaning task.

- Clean the equipment with a damp cloth with a

few drops of washing-up liquid and then dry.

- Do not use solvents, or products with an acid or

base pH such as bleach, or abrasive products,

for cleaning the appliance.

- Never submerge the appliance in water or any

other liquid or place it under running water.

- Never submerge the connector in water or any

other liquid or place it under running water.

- Then dry all parts before its assembly and storage.

- In order to ensure optimum quality of the cubes,

it is recommended that you change the water

every 24 hours.

ANOMALIES AND REPAIR

- Take the appliance to an authorised technical

support service if product is damaged or other

problems arise. Do not attempt to disassemble

or repair the appliance yourself as this may be

dangerous.

If any anomaly is detected, check the following

table:

FOR EU PRODUCT VERSIONS AND/OR IN

CASE THAT IT IS REQUESTED IN YOUR

COUNTRY:

ECOLOGY AND RECYCLABILITY OF THE

PRODUCT

- The materials of which the packaging of this

appliance consists are included in a collection,

classication and recycling system. Should you

wish to dispose of them, use the appropriate

public recycling bins for each type of material.

- The product does not contain concentrations of

substances that could be considered harmful to

the environment.

This symbol means that in case you wish to

dispose of the product once its working life

has ended; take it to an authorised waste

agent for the selective collection of Waste

from Electric and Electronic Equipment

(WEEE).

This symbol means that surface could to

get hot during the use.

This appliance complies with Directive 2014/35/

EU on Low Voltage, Directive 2014/30/EU on Elec-

tromagnetic Compatibility, Directive 2011/65/EU

on the restrictions of the use of certain hazardous

substances in electrical and electronic equipment

and Directive 2009/125/EC on the ecodesign

requirements for energy-related products.

PROBLEM POSSIBLE CAUSES POSSIBLE SOLUTIONS

The compressor is

operating abnormally and

makes a humming sound.

The voltage is lower than

recommended.

Do not connect the appliance to the

mains supply if the voltage indicated

on the rating plate does not corres-

pond with that of the mains voltage.

The «Tank empty» indica-

tor light lights up.

The water tank is empty.

There is air in the water pump.

Turn off the appliance, ll the tank

and wait 3 minutes before restarting

the appliance.

Remove the silicone plug and leave

a few drops of water.

Despite having observed

all indications, no cubes

are forming.

Lack of coolant in the freezer

or the fan motor is damaged.

Contact your dealer or after sales

service.

The «Tank empty» and

«Tray full» indicator lights

light up at same time.

If all conditions are being

followed, the cube ejector may

be blocked.

Turn off and disconnect the applian-

ce, in order to remove the ice cubes.

Turn the appliance back on.

Page is loading ...

Taurus Alpatec MG 15 DIGITAL Owner's manual

Taurus Alpatec MG 15 DIGITAL Owner's manual

in other languages

Related papers

Other documents