Stereo
AC12K2
Blue
Red
Battery
Black
OPTION 1
Model: AC12K2
1111 West Victoria Street
Compton, CA 90220 www.magnadyne.com
© Copyright 2012 Magnadyne
AC12K2-IM Rev. A 11-7-12
With the increasing sophistication of vehicle radios the need for noise
suppression is ever increasing. Although we cannot guarantee with
absolute certainty this producs will eliminate every problem, in most
cases it will drastically improve the situation.
Install this noise suppressor following the instructions and diagrams:
1. Cut the red fuse wire between the fuse and the radio. Strip
approximately 1/2” of insulation from each side of the cut wire.
2. Connect the Blue wire to the side of the cut wire which returns
to the stereo.
3. Connect the Red wire to the side of the cut wire which returns
to the fuse panel or power source.
4. Connect the black wire to ground.
5. Use the screws supplied to mount the noise suppressor.
Note: Because of varied conditions it may be necessary that you
reverse the Red and Blue wires or not ground the Black wire. Try
more than one options to get the best results for you particular
vehicle.
7
83855 11003
1
Made in China
To Ground
Fuse
Cut Wire
Stereo
AC12K2
Blue
Red
Battery
Black
OPTION 2
No Connection
Fuse
Cut Wire
Stereo
AC12K2
Red
Blue
Battery
Black
OPTION 3
To Ground
Fuse
Cut Wire
Stereo
AC12K2
Red
Blue
Battery
Black
OPTION 4
No Connection
Fuse
Cut Wire
Installation Instructions
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
PYLE Audio PLPK65TVD User manual
-
Alpine CDA-9811 User manual
-
-
-
Alpine CDA-7867 User manual
-
Alpine CDE-130R User manual
-
Alpine HCE-C105 - Rear View Camera System Owner's manual
-
Alpine SWE-1000 Owner's manual
-
Alpine CDE-120RR Owner's manual
-
PYLE Audio PLCDCS300 User manual
