2. Logosol
  3. Bar Nose Steering Saw Units

Logosol Bar Nose Steering Saw Units Assembly Instructions

  • Hello, I have reviewed the assembly instructions for the LOGOSOL Bar Nose Steering 0458-395-0241. This document provides the necessary guidance for assembling the steering component to both chainsaw and electric saw carriages. The document also describes how to adjust the attachment using the magnet holder, and specifies the required parts, including bolts and nuts. I am ready to answer any questions you may have regarding this document or the assembly process.
  • What type of bolts are used for assembly?
    How many flange lock nuts M8 are needed?
    Is there a tube end cap?
ASSEMBLY INSTRUCTIONS
BAR NOSE STEERING
SAW UNITS
EN
1 x
1 x
1 x
1 x
03-02783
03-02785
03-02786
03-02787
Ref. no. 0458-395-0241
Bolt bag
Bar nose steering
Allen bolt M8x16
Tube end cap
Allen bolt M5x16
Allen bolt M5x10
8 x
1 x
8 x
1 x
1 x
1 x
Flange lock nut M8
Magnet
COMPONENTS
2
ASSEMBLY: BAR NOSE STEERING
Allen bolt M8x16
Allen bolt M8x16
4 x
2 x
4 x
2 x
1 x
Flange lock nut M8
Flange lock nut M8
Magnet
1
2
3
Allen bolt M5x16 or M5x10
1 x
Fit the tube end cap to the bar nose steering tube.
If there is no hole in the
guide bar nose, you can
use a shorter bolt that
does not protude below
the magnet.
ACCESSORY BAR NOSE STEERING
3
ASSEMBLY: BAR NOSE STEERING
Allen bolt M8x16
Allen bolt M8x16
2 x
2 x
2 x
2 x
Flange lock nut M8
Flange lock nut M8
Installing the bar nose steering onto an electric saw carriage.
Installing the bar nose steering onto a chainsaw carriage.
4
ADJUSTMENTS
With the magnet holder on the bar nose steering you
can adjust the the bar nose attachment in height and
sideways.
In the tube of the bar nose steering there are oblong holes. Adjust
the position of the bar nose steering tube, so that the bolt through
the magnet comes into place in the hole in the guide bar nose.
If there is no hole in the guide bar nose, you can use a
shorter bolt that does not protude below the magnet.
/