Western Back Drag Edge Kits (V-Plow) #44281-3, 44282-3, 44283-3, 44283-4 Installation guide
- Type
- Installation guide
44281-3, 44281-4, 44282-3, 44283-3, 44283-4
3. Remove and retain the locknuts securing the
driver's side of the cutting edge to the blade.
Leave the cutting edge in place and replace the
bolts with the provided 5/8" x 2-1/2" carriage bolts.
4. Install the driver-side back drag edge against the
back of the blade base angle. Secure with the
provided 5/8" washers and the original locknuts.
5. Torque fasteners to 150 ft-lb.
6. Repeat Steps 3–5 on the passenger's side.
7. Turn the vehicle ignition and the control ON. Raise
the blade until the T-frame is raised off the jack
stands. Turn the control OFF and remove the jack
stands.
8. Stand 8' clear of the blade and lower the blade to
the ground.
A DIVISION OF DOUGLAS DYNAMICS, LLC
INSTALLATION INSTRUCTIONS
1. Park the vehicle on a smooth, level, hard surface,
such as concrete. Raise the blade, then turn the
control OFF. From the side of the blade assembly,
place jack stands under the T-frame.
2. Turn the control ON, then lower the blade until the
T-frame rests on the jack stands. Turn the control
and vehicle ignition OFF.
CAUTION
Use standard methods and practices
when attaching snowplow and installing
accessories, including proper personal
protective safety equipment.
CAUTION
See your sales outlet for specifi c vehicle
application recommendations before
installation. Back drag edge kit weight
information can be found in the online
selection system.
CAUTION
Read this document before installing the back
drag edge kit.
WARNING
Do not exceed GVWR or GAWR, including
blade and ballast. The rating label is found on
the driver-side vehicle door cornerpost.
WARNING
Blade can drop unexpectedly. Place T-frame
on jack stands. Failure to do so could result in
serious personal injury.
Back Drag Edge Kit
V-Plow Snowplows
August 1, 2020
Lit. No. 43589, Rev. 03
Provided
5/8" x 2-1/2" Carriage
Bolt
Back
Drag
Edge
Blade Base
Angle
Cutting
Edge
Provided
5/8" Washer
Original
Locknut
44281-3, 44281-4, 44282-3, 44283-3, 44283-4
Lit. No. 43589, Rev. 03 2 August 1, 2020
The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when
so altered without reference to illustrations or specifi cations used. This equipment manufacturer or the vehicle manufacturer may require or
recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. The company off ers a limited warranty for
all snowplows and accessories. See separately printed page for this important information.
Printed in U.S.A.
-
1
-
2
Western Back Drag Edge Kits (V-Plow) #44281-3, 44282-3, 44283-3, 44283-4 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Western Back Drag Edge Kits #44281-2, 44282-2, 44283-2 - MVP PLUS Installation guide
-
-
-
-
-
-
-
-
-