English
12
Note: Some restrictions may apply when selecting wash option(s) with wash
programs. Read "Wash Option Selecting Procedure" section on page
numbers 10-11 for more details.
Note: If you are not satisfied with the wash program and wash option(s) that you
have selected, simply press the "POWER" button to turn off the unit. To
reselect new wash program and option(s), press "POWER" button again to
turn the unit "ON". Reselect the new wash program and wash option(s).
4) Press the "START/PAUSE" button to start the timer. At this time, all the selected:
Wash Program, Wash Option(s) and Delay Time Display with selected "Hours"
lights will blink. The wash process will begin automatically after an hourly delay
countdown.
Note: At the end of the wash program the machine will beep for few times to
indicate that the wash process has been completed. All the lights except for
the power indicator light will turn off
5) Remove all washed items and reload if you would like to start a new wash process
or press the "POWER" button to turn the unit "OFF" at the end of wash process.
Once the unit is in the "OFF" position, the power indicator light shuts off.
Understanding the Convection Fan Dry Process:
• The convection fan activates automatically after each wash program to start the
drying cycle. During the drying process the fan removes hot moist air to
condensation chamber. The condensed hot moist air cools down ito form water and
is exhausted through the drainpipe.
• With this type of exhaust design in your dishwasher, there is no need to worry
about your cabinets getting damaged, unlike other conventional dishwashers with a
front vent opening to exhaust hot moist air which may easily spread around the
cabinets and cause damage.
Upper Wash Option:
This option can be used with ALL wash programs.
Note:You can select this option when you want to wash small load of dishware
and glassware. You must load items in the “UPPER RACK ONLY.” The lower
rack must be completely empty when using this option. During the wash
process, the water flow from the upper sprayer is concentrated only on the
wash load in the upper rack.
Note:You must use “ONE HALF” the amount of detergent that you would normally
use for full a load. This option saves detergent, water and energy. Follow the
steps below to select the wash option for each program.