iRobot Scooba 200 Series Quick Start Card

Brand: iRobot

Model: Scooba 200 Series

Type: Quick Start Card

iRobot Scooba 230 Quick Start Guide

www.irobot.com

iRobot Scooba 230 Quick Start Guide

Scooba is designed for use on hard ﬂoor surfaces, including tile, linoleum, vinyl, marble, slate and

sealed wood. Do not use Scooba on unﬁnished or unsealed hard ﬂoors, stone ﬂoors, carpets, rugs or

waxed ﬂoors.

Step 1. Charge Scooba

Step 2. Prepare the room

Put in Scooba’s battery.

Sweep the ﬂoor

or run Roomba.

Plug in and charge

Scooba up to 8 hours.

(The charger ﬂashes

twice when plugged in,

to show it has power.)

Remove clutter and area rugs in the room to be cleaned.

TIP: To extend the battery life, always store Scooba connected to a plugged-in charger.

NOTE: When Scooba is fully charged, the light on the charger is solid green.

iRobot Scooba 230 Quick Start Guide

www.irobot.com

Step 3. Set up Scooba

Step 4. Clean Scooba

Open both the Fill

and Empty Ports.

Slowly add warm

water in the Fill Port.

Add Scooba Hard

Floor Cleaner (either

one pre-measured

packet or one-half

of a cap full).

Firmly close the

Fill and Empty

Ports until

sealed.

Place Scooba in the

middle of the dirtiest

area of the ﬂoor.

Press the Power button

to turn on Scooba.

For short cycle,

press and hold clean

until second song

plays. (20 minutes,

up to 60 sq. ft.)

For the long cycle, press clean once.

(45 minutes, up to 150 sq.ft.)

Empty and thoroughly rinse both the Fill

and Empty Ports with water after each use.

Take off the bottom plate. Rinse and

remove debris from brushes and

squeegee.

Remove any debris on the robot before

replacing the bottom plate.

TIP: To protect bottom plate brushes, keep Scooba on storage mat, when not in use.

TIP: Use only Scooba Hard Floor Cleaner or tap water; other solutions may damage Scooba.

CLEAN

power

iRobot Scooba 200 Series Quick Start Card

iRobot Scooba 200 Series Quick Start Card

iRobot Scooba 200 Series Quick Start Card

Related papers

Other documents