Spektrum DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4 User manual

Spektrum
Brand
Spektrum
Model
DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4
Type
User manual

This manual is also suitable for

Spektrum DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4 is a versatile and powerful radio control system designed for experienced RC enthusiasts. With its 10 channels, it offers precise control over a wide range of RC models, including airplanes, helicopters, drones, and boats. The DX10t features a user-friendly interface with a large, backlit LCD screen that provides clear and easy-to-read information. It also has a built-in telemetry system that allows you to monitor important data from your model in real time, such as battery voltage, signal strength, and altitude.

Spektrum DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4 is a versatile and powerful radio control system designed for experienced RC enthusiasts. With its 10 channels, it offers precise control over a wide range of RC models, including airplanes, helicopters, drones, and boats. The DX10t features a user-friendly interface with a large, backlit LCD screen that provides clear and easy-to-read information. It also has a built-in telemetry system that allows you to monitor important data from your model in real time, such as battery voltage, signal strength, and altitude.

SPMA3012
ADDENDUM
[DX10t GIMBAL STICKS] // SPMA3012 ERGÄNZUNG (DX10T STEUERKNÜPPEL)
1. With the transmitter OFF, move the 3-Position
switch(es) to the forward (0) position, then
power ON the transmitter. The Raw Input Test
screen appears.
2. When you move the 3-Position switch(es),
you can verify the proper installation under
“STICKS”.
3. Power OFF the DX10t, then power it ON as
you normally would. Enter the “System Setup”
screen and scroll to the “Clear/Back/Auto Trim
Setup”, then press the roller.
4. Change the “Left Stick Type” to 3-Position
(if applicable).
5. Change the “Right Stick Type” to 3-Position.
When you change the Stick Type to
3-Position, the left stick switch is assigned
to “Switch S” and the right stick switch is
assigned to “Switch T”.
We have been informed that the Raw Input Test screen may appear after the 3-Position Gimbal Sticks (SPMA3012) are installed in the DX10t
transmitter. Please follow the instructions below to confi gure your DX10t and prevent the Raw Input Test screen from appearing in the future.
1. Schalten Sie bei ausgeschalteten Sender
den 3 Positionschalter nach vorne auf die
0 Position und schalten dann den Sender ein.
Das RAW Input Test Menü erscheint.
2. Wenn Sie jetzt den 3-Positionsschalter
betätigen, können Sie unter “STICKS”
die einwandfreie Funktion des Schalters
veri zieren.
3. Schalten Sie die DX10t aus und dann
wieder normal ein. Gehen Sie in die
Systemeinstellung und scrollen zu
Knüppelschalter Einstellung. Drücken Sie zur
Auswahl den Rolltaster.
4. Wechseln Sie die Einstellung des linken
Knüppel auf 3-Positionen.
5. Wechseln Sie die Einstellung des rechten
Knüppel auf 3-Positionen.
Wenn Sie den Knüppelschalter wechseln ist
der linke Knüppelschalter ist dem Schalter “S”
zugeordnet, der rechte dem Schalter “T”.
Wie wir informiert wurden erscheint das Menü des RAW Input Test nachdem der optionale Steuerknüppel mit 3-Positions-Schalter in die DX10t
eingebaut wurde. Bitte folgen Sie den untenstehenden Anweisungen um ihre DX10t einzurichten und damit zu verhindern, dass der RAW Input Test
noch einmal aktiv wird.
Funktion
Schalter S
Schalter T
A
B
A
B
Function
Switch S
Switch T
A
B
A
B
© 2012 Horizon Hobby, Inc.
The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Created 12/12 38908
  • Page 1 1

Spektrum DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4 User manual

Spektrum
Brand
Spektrum
Model
DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4
Type
User manual
This manual is also suitable for

Spektrum DX10t 10-Channel Transmitter/Receiver OnlyMode 1-4 is a versatile and powerful radio control system designed for experienced RC enthusiasts. With its 10 channels, it offers precise control over a wide range of RC models, including airplanes, helicopters, drones, and boats. The DX10t features a user-friendly interface with a large, backlit LCD screen that provides clear and easy-to-read information. It also has a built-in telemetry system that allows you to monitor important data from your model in real time, such as battery voltage, signal strength, and altitude.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents