E-flite EFLC2002 User manual

Brand: E-flite

Model: EFLC2002

Category: Battery chargers

Type: User manual

Thank you for purchasing an E-flite™ charger.

This DC-powered 7.2-8.4V time charger will

allow you to fast charge Ni-Cd and Ni-MH

battery packs for your electric glider. When

used properly following these instructions,

this charger will provide many years of

trouble-free operation.

• Charges 6- or 7-cell 1200-2000mAh

Ni-Cd and Ni-MH packs

• 20- to 30-minute charger w/timer

• Heavy-gauge wire with large alligator clips

• Tamiya connector

This DC Fast Charger requires a 12V power

source, such as a 12V 7-amp Sealed Battery

(HAN102) or an automobile 12V battery.

• Input Leads: 6ft w/large alligator leads

• Output Leads: 1ft w/Tamiya-style connector

• Timer: 30 minutes

• Case Size: 5

3

/

4

" x 3" x 2"

• Charge Indicator: red LED

• Trickle-Charge Rate: 30mAh

• Charge Rate: 3.6 amps

• Do not attach the charger to an auto-

mobile battery while the engine is running.

• Do not leave the charger unattended

while you are charging a battery pack.

• Continuously monitor the temperature

of the battery pack while it is being

charged. If the pack at any time becomes

very warm to the touch, disconnect the

battery immediately.

Instructions

EFLC2002 Features

Supplying Power to the Charger

EFL2002 Specifications

EFLC2002

DC Fast Charger

for Electric Gliders

Safety Tips

EFLC 2002 Instruction 2/11/02 11:16 PM Page 1

1. Prior to charging, make sure the battery

pack is completely discharged by running

the electric motor until it slows down.

Note: Discharge the Ni-Cd pack every

cycle. Failure to do so will decrease the

capacity and flying time of the battery.

2. For best results, let the battery pack cool

before charging. Heat can prevent a battery

from charging to full capacity and also

decreases the performance of the battery.

3. Once the pack is ready to be charged,

attach the red (positive +) alligator clip to

the red "positive" terminal of the 12V

power source.

4. Attach the black (negative-) alligator

clip to the "negative" terminal of the

12V power source.

5. Make certain that you hook up the

charger to the correct polarity of the

12V power source.

6. Use the graph provided on the back of the

charger to select the correct charge time

needed to fully charge the battery pack.

The graph will give a recommended

charging time (of a fully discharged

battery) based upon the capacity of your

battery pack.

7. Continue to monitor the battery as it is

being charged. After the battery has been

fully charged, disconnect the charger from

the battery.

If you encounter any problems with

your E-flite™ charger, contact the

Horizon Service Center at (877) 504-0233.

Charging Your Battery

Service

Visit our Web site at www.horizonhobby.com

TM

EFLC 2002 Instruction 2/11/02 11:16 PM Page 2

1
2

E-flite EFLC2002 User manual

Brand: E-flite

Model: EFLC2002

Category: Battery chargers

Type: User manual

Download PDF

Related papers

Other documents