Tefal DT7050 User guide

  • Hello! I've reviewed the provided appliance user manual and I'm ready to assist you with any questions you might have. This document outlines troubleshooting steps for common issues such as lack of steam, heating problems, leaks, and other common issues. I can help you understand how to get the most out of your device.
  • What should I do if there is no steam?
    What should I do if the appliance is no longer heating?
    What should I do if I see water leaks?
    What could cause steam output to decrease?
    What to do if appliance produces steam constantly?
    What causes steam to stain clothing?
FAQ
There is no more steam.
Your product is not plugged in or is not switched on ==> Check that your product is properly
connected to a power socket and that the switch is on "I".
The water level in the tank is too low ==> Unplug the appliance and fill the tank.
The pump is unprimed ==>Press and hold the steam button for a few seconds to prime the pump.
The removable tank is not installed correctly ==> Check the correct positioning of the tank on
the product.
The product is in "Stand-by" mode ==> Press the "On-Off" button and wait until it stops
flashing.
The appliance is no longer heating.
Your product is not plugged in or is not switched on ==> Check that your product is properly
connected to a power socket and that the switch is on "I".
The product is in "Stand-by" mode ==> Press the "On-Off" button and wait until it stops
flashing.
I can see water leaks.
The water tank is not installed correctly or its locking valve is not closed properly ==> Check
that the valve is closed and that the tank is installed correctly on the product.
The steam output decreases.
Your appliance has limescale, consult the "Descaling" section in the instructions.
The appliance produces steam constantly.
The "Steam" button is in Continuous Steam position. Unlock it by pressing it once.
The steam stains clothing.
You have used descaling chemicals or additives in the water.
Never add such products to the water tank. These contain organic waste or minerals that
condense under the influence of heat and cause spitting, brown dripping or premature aging of
your device.
The appliance is spitting water.
You have used descaling chemicals or additives in the water.
Never add such products to the water tank. These contain organic waste or minerals that
condense under the influence of heat and cause spitting, brown dripping or premature aging of
your device.
What should I do if my appliance is not working?
After following the instructions in the user manual for starting the appliance, make sure that your
electrical socket is working by plugging another appliance. If it still does not work, do not try to
dismantle or repair the appliance yourself, instead, take it to an approved repair centre
/