2. MONDOLUX
  3. MD35AR
MD35AR

MONDOLUX MD35AR User manual

  • Hello! I have analyzed the provided installation manual for the Mondolux Albi Maxi Angular MD35AR Downlight. This document includes important safety warnings, step-by-step installation instructions, and key specifications. I am ready to answer your questions about installation, usage, or any other related topic.
  • What is the required power input for this fitting?
    What should I do before installing this product?
    Can I interchange parts of this fitting?
    What is the recommended distance between the fitting and the illuminated subject?
Installation Manual
Warnings
•The safety and compliance of this fitting are not assured unless the following instructions are adhered to. Please retain these instructions
for future reference.
•Always turn the mains OFF prior to installation. See Picture below.
•The luminaire is EN 60598-1:2015/A1:2018 compliant and Installation must be carried out by a licensed electrician.
•Risk of Electric Shock: Prior to installation or maintenance, disconnect the fitting from power supply and other control wiring. Faulty
cables and wiring need to be replaced by manufacturer only.
•Risk of Burns: When in use, the fitting's surface may reach high temperatures and can cause skin burns. It is recommended to install the
fitting out of reach to avoid any physical contact.
•It is recommended to always wear safety glasses and gloves during installation.
•For safety reasons please keep children away from installation site.
•Please follow below instructions for disposal in accordance with the local E-Waste or WEEE (Waste Electrical and Electronic Equipment):
oFittings cannot be disposed alongside other household waste.
oRemove the lamp/ battery for decommissioning (if applicable)
oSend them to nearest E-Waste or WEEE collection center.
•For further inquiries, please contact Mondolux at https://www.mondolux.com.au/
Product code mondolux.com.au
Albi Maxi Angular
DOWNLIGHT MD35AR
Ø75mm
*Module Heights
9W - 100mm
15W - 120mm
20W - 135mm
*
Installation Manual
Notes
⚫ This fitting requires 220-240V AC/50Hz power input to the driver.
⚫ Do not interchange any parts of this fitting.
⚫ Its recommended to have some space around the fitting for air ventilation to extend product
lifetime.
⚫ Allow a minimum distance between fitting and illuminated subject of 800mm.
⚫ Do not touch fitting when in use.
⚫ Do not cover with any form of heat proof material. Do not install fitting near any heat source.
⚫ Do not install any inductive loads such as exhaust fans etc. within the same lighting circuit of the
current fitting. Issues caused by such connections will not be covered under our warranty policy.
⚫ If you have any questions about the installation of this product, please contact Mondolux.
Installation Steps
1. Ensure the mains power is turned off.
2. Cut required holes in ceiling. Ensure minimum space requirements between fitting and driver. See
picture 1.
3. Pass the driver power supply wires through the cutout and plug into mains socket.
4. Connect the driver to the light fitting using the quick connector. See picture 2.
5. Mount the fitting into the ceiling and secure using spring clips. See picture 3 and 4.
6. Installation is complete. See picture 5.
Product code mondolux.com.au
Albi Maxi Angular
DOWNLIGHT MD35AR
Picture 1
ON
OFF
Ø75mm
Ø75mm
Picture 2
ON
OFF
Picture 4Picture 5Picture 3
/