AC-WILDCAT-X-RW03

FALCON RIDGE AC-WILDCAT-X-RW03 User manual

  • Hello! I've reviewed the instructions for the Falcon Ridge Wildcat X Aero-Vent Polycarbonate Rear Window. This document covers the parts included, installation steps, and cleaning guidelines. I'm ready to answer any questions you may have about the product and its installation process.
  • What should I do before removing the protective film?
    What should I do if parts are damaged or missing?
    How should I clean the windshield?
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Arctic Cat / Textron Wildcat X
Aero-Vent Polycarbonate Rear Window
AC-WILDCAT-X-RW03
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you
are happy with the product before removing protective film. Once the film is removed you cannot return
the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the Wildcat X Aero-Vent
Polycarbonate Rear Window.
1. Check over the parts included in the cartons with the parts list shown below:
1 ¾” Loom Clamps 6 each
1 Bolts 6 each
2” Bolts 1 each
Thumb Nuts 6 each
Lock Nut 1 each
Small Washers 6 each
1 ¼” Black Spacer 1 each
Slide Fasteners 5 each
4End Bulb Rubber Gasket 2 each
9” End Bulb Rubber Gasket 2 each
Vent Sliders 1 each
Rear Window 1 each
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2. Start by pulling it out of the box, find a clean area to lay it down, and install the hardware. Begin by
peeling off the protective film. Next take the 4 and 9” pieces of rubber gasket and starting at one end
firmly place along the bottom edge of the Windshield as shown in the photo below.
3. Next prepare the vent slider to be installed on the windshield. Take the 2” bolt, Black nylon spacers and
lock nut and attach them to the vent sliders as shown in the photos below.
4. Take the spacer and slide it over the bolt as shown below
5. Now insert the bolt in the small holes and screw on the lock nuts so the end of the bolt is flush with the
outside edge of the lock nut.
6. Now place the sliders on the inside surface of the windshield. And place the plastic slide fasteners
through the slots on the slider and into the holes in the windshield. The lock nuts should be in the large
slots of the windshield. See photo below.
7. You are now ready to install the windshield on your roll cage.
8. Take the six Loom clamps and place them around the roll cage at each of the slots on the sides and
across the top as shown in the following photos.
9. Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of
some sort to decrease the chance of scratches. We recommend using micro fiber cloths that are readily
available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag
or micro-fiber cloth to clean it.
Thank you for your purchase!
Return Policy
If for any reason you choose to return this product it must be returned within 30 days from date item is
received. You MUST package the product exactly as it was originally packaged from the factory to get a
full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the
windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the
windows.
All returned products will be inspected upon arrival at the production facility and must be in unused,
factory new condition to receive refund - a 25% restocking fee will apply.
If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our
preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying
the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization
number will be charged a 20% restocking fee. If ordered from one of Falcon Ridges many distributors, you
must first call them and see what their return policy is. Once your item reaches our production facility, our
customer satisfaction team will inspect your item to ensure unused, factory new condition. NOTE: All
windshields must be returned with the original protective film intact and not removed. Do NOT
REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only
be processed on items with original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your
returned item arrives back factory fresh, and in new resalable condition (any returned items that have been
used, altered or damaged in any way will not be subject for a refund.) All contents including instruction
manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM
factory new condition will be approved. Once returned items are received, credit will be issued to the original
credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be
refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms
under which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to
defect of the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct
the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement
we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of
purchase.
/