Eglo 205291A Operating instructions

Type
Operating instructions

Eglo 205291A is a lighting fixture that can be installed on a ceiling. It requires professional installation by a person familiar with its construction and potential hazards. Before starting the installation, the electrical power at the breaker panel must be turned off. The product's height can be adjusted, but the minimum cord length between the canopy and the luminaire frame must be at least 100mm (4 inches) to protect the cord from damage.

Eglo 205291A is a lighting fixture that can be installed on a ceiling. It requires professional installation by a person familiar with its construction and potential hazards. Before starting the installation, the electrical power at the breaker panel must be turned off. The product's height can be adjusted, but the minimum cord length between the canopy and the luminaire frame must be at least 100mm (4 inches) to protect the cord from damage.

SAFETY PRECAUTIONS:
MESURE DE SÉCURITÉ: (MISE EN GARDE)
PRECAUCIONES DE SEGURIDAD:
INSTRUCTIONS
INSTRUCCIONES
205291A / 205292A - RAFAELINO
1. Turn off electrical power at breaker panel before starting installation of light xture (see g. A)
2. This product must be installed in accordance with the applicable installation code by a person familiar with
the construction and operation of the product and the hazards involved.
NOTE: product may not look exactly as shown in gures.
1. Fermez le courant au disjoncteur avant de débuter l’installation de la xture. (voir la g. A)
2. Ce produit doit être installé selon le code d’installation pertinent par une personne qui connaît bien le produit
et son fonctionnement ainsi que les risques inhérents.
N.B.: le produit peut différer de l’illustration.
1. Corte la corriente eléctrica antes de comenzar la instalación de la lámpara. (vea g.A)
2. Este producto debe ser instalado conforme al código de instalación, aplicable por una persona con
conocimiento en la construcción y operación del producto y los peligros que implica.
NOTA: el producto puede no ser exactamente igual al mostrado en la gura.
Imported by / Importé par / Importado por:
Eglo Canada Inc. / Eglo USA Inc. / Eglo México Iluminación S de RL de CV www.eglo.com
INSTRUCTIONS
INSTRUCCIONES
205291A / 205292A - RAFAELINO
OFF
A
2
a
c
b
HEIGHT ADJUSTMENT:
Always keep the fiberglass sleeve
between the strain relief and the cord
to protect the cord from damage.
AJUSTEMENT DE LA HAUTEUR:
Veuillez vous assurer de garder la
membrane de fibre de verre sur le fil
électrique entre le serre-fils afin déviter
que le fil électrique sendommage.
AJUSTE DE ALTURA:
Mantenga siempre la envoltura de
fibra de vidrio entre el liberación de la
tensión y el cordón para proteger el
cable contra daños.
CAUTION:
Minimum cord length between the canopy
and luminaire frame 100mm (4”)
ATTENTION:
La longueur minimum de corde entre la
canoe et le luminaire doit être d’un
minimum de 100mm (4”)
PRECAUCN:
El largo mínimo del cable entre la caja de
montaje y la luminaria debe ser 100mm (4”)
5
ON
B
C
17
6
4
3
Black / Noir / Negro
White / Blanc / Blanco
Ground / Mise à la terre / Tierra
8
  • Page 1 1
  • Page 2 2

Eglo 205291A Operating instructions

Type
Operating instructions

Eglo 205291A is a lighting fixture that can be installed on a ceiling. It requires professional installation by a person familiar with its construction and potential hazards. Before starting the installation, the electrical power at the breaker panel must be turned off. The product's height can be adjusted, but the minimum cord length between the canopy and the luminaire frame must be at least 100mm (4 inches) to protect the cord from damage.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI