Electric oven instruction manual
1. Check whether the power supply installation is normal and reliable.
2. When using, check whether there is water in the basin and check the installation precautions
once.
3. After the power switch is turned on, the green indicator light is on, and the water volume
needs to exceed 1/2 of the water basin. Thermostat, align the required temperature scale value
with the pointer of the knob, at this time the current has been supplied to the wood stove, as
long as the Rotate the electric heating tube clockwise to start heating up. When the heating tube
exceeds the required temperature, the yellow indicator light is on, indicating that the electric
heating tube is working, the thermostat can automatically cut off the power supply, and at the
same time, the yellow indicator is off, and the electric heating tube stops working. When the
temperature drops to a certain temperature, Wenji recruits the electricity of Fan Self-Service
Building. When matching, the yellow indicator light is on, the electric heating tube works again,
and the temperature of the heating tube rises. This cycle is repeated to ensure that the heating
tube is kept at a constant temperature within the set temperature range.
4. The water basin is designed to keep the furnace clean and warm. When using it, you should
pay attention to whether there is water in the water basin, so as to avoid the temperature being
too high and burning the bottom. It is also for maintaining hygiene.
5. There is a special mesh frame inside, try to clean it when using it. Align the position and place
it on the top of the oven lightly. When grilling, apply a layer of oil on the grill to prevent the food
from sticking to the grill! When you stop using it, you should clean the grill to facilitate the next
use!
6. After use, please rotate the thermostat counterclockwise to the limit position, cut off the
power supply, and ensure safety.
7. When you need to clean the oven, first pull out the water basin from the bottom, pour out the
sewage in the basin, rinse it with clean water, and then dry it with a dry towel. After the
temperature of the mesh rack has dropped, remove the mesh rack from the oven, clean it with a
brush, and store it immediately. Wipe off any stains on the oven surface with a towel.
8. In order to make the oven safe and durable, the user should regularly remove the residues in
the oven and the dirt on the electric heating pipe, so as to keep the oven clean for a long time,
and the heating pipe can be used for a longer time.
9. Note: Do not touch the heating tube when it is working to avoid burns. After unplugging the
power supply, wait for the temperature of the heating tube to drop to a state where there is no
harm to the human body before operating the oven!
10. This manual is not suitable for persons (including children) who are physically, sensory or
intellectually handicapped, or who have limited experience and knowledge.
12. Dangerous voltage: there are live parts with a working voltage greater than 250V
13. The connection and fixed wiring is equipped with an all-pole disconnection device with a
contact distance of at least 3mm.
14. The appliance shall not be cleaned with jet water.
15. If the power cord is damaged, it must be replaced by professionals.
16. In order to ensure heat dissipation, the installation distance between the back and both sides
of the product and the wall must be maintained at more than 50m.