2016 Land Rover Discovery Sport (L550) L4-2.0L Turbo
Vehicle > Engine, Cooling and Exhaust > Engine > Timing Components > Timing Chain > Service and Repair >
Removal and Replacement
TIMING CHAIN - REMOVAL AND INSTALLATION
TIMING CHAIN
REMOVAL AND INSTALLATION
PART(S)
STEP PART NAME QUALIFICATION QUANTITY
Installation Step 1 friction washer
Crankshaft sprocket 1
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
style procedures can be identified by steps that have no accompanying step text and the magenta
color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
TAS
removal and installation procedures use a sequence of color illustrations to indicate the order to be
followed when removing/disassembling or installing/assembling a component.
TAS
Many of the procedures will have the installation information within the removal steps.TAS
The color illustrations use a variety of symbols to indicate important details of the procedures. It is
important to understand these symbols in order to properly used the TAS procedures.
TAS
Refer to "How to Use TAS Procedures" and "TAS Symbol Glossary" at
for additional information on these procedures.
Vehicle | Description and Operation
TAS
REMOVAL
CAUTION:
Prior to installing the , make sure that the is at the top dead centre (TDC)
cylinder 1.
timing components crankshaft
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
Disconnect the battery ground cable. For additional information, refer to: (
)
1. Specifications 414-01
Battery, Mounting and Cables, Specifications
Raise and support the vehicle.
2.
WARNING:
Make sure to support the vehicle with axle stands.
For additional information, refer to: (
)
3. Timing Cover 303-01B Engine - GTDi 2.0L Petrol/GTDi 2.0L Petrol -
SULEV, Removal and Installation
4.
5.
6.
Remove the timing chain.
7.
8.
NOTE:
Discard the washer.
INSTALLATION
1.
NOTE:
Install a new washer.
Renew Part: Quantity: .Crankshaft sprocket friction washer 1
Install the timing chain.
2.
3.
Torque:
10 Nm
4.
5.
Torque:
10 Nm
For additional information, refer to: (
)
6. Timing Cover 303-01B Engine - GTDi 2.0L Petrol/GTDi 2.0L Petrol -
SULEV, Removal and Installation
Connect the battery ground cable. For additional information, refer to: (
)
7. Specifications 414-01 Battery,
Mounting and Cables, Specifications
/
