Homelite ut33601, ut33651 Owner's manual

Type
Owner's manual
First Time Assembly
First Time Start
Remove product from carton.
Assemble per instructions
in your operator’s manual.
1
WARNING: This Quick Start Guide is not a substitute for reading the
operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
2
3
Spread handle over boom and
snap into place. Secure with bolt,
washer, and wing nut.
Snap shield into place over boom and bracket.
Secure with bolt, washer, and wing nut as shown.
4
Align and assemble 2 booms
until fully seated. Tighten
screws with provided hex key.
- OR -
Curved Shaft
Straight Shaft
Mix 2.6 oz. 2-cycle oil with
1 gallon of fresh gasoline in
separate gas container. Shake,
then pour into trimmer tank.
5
6
7
7
Place trimmer on ground
with the trim head end facing
away from you.
Repeatedly press the primer
bulb 10 times.
Squeeze and hold trigger.
9
8
Set choke lever to A
start position.
Pull quickly and powerfully
to start (6x MAX.)
Continue to squeeze and
hold trigger to allow
engine to warm up.
If engine does not start,
REPEAT STEPS
11
12
Set choke lever to
B run position.
NOTE: There is a detent location
between positions A and B
to help ease starting
and warm up, if needed.
You are now ready to Trim!
If engine did not start,
REPEAT STEPS
To stop trimmer, press the
red switch located on the
side of motor housing.
Go to www.homelite.com and register your new tool online.
For any questions about operating or maintaining your product,
call the Homelite® Help Line!
1-800-242-4672
Your Product has been fully tested prior to shipment to ensure
your complete satisfaction. Troubleshooting tips are also
available in your operator’s manual.
For additional registration instruction, refer to operator’s manual.
10X
TRIM!
10
10
990000927
2-28-14 (REV:01)
7
11
CALL
www.homelite.com
  • Page 1 1
  • Page 2 2

Homelite ut33601, ut33651 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI