davoline OR 9.20 Safety & Operating Instructions Manual

Type
Safety & Operating Instructions Manual
OIL FILLED RADIATOR
Safety & Operating Instructions
Model # OR 9.20
OR 13.25
READ ALL INSTRUCTIONS BEFORE USING THIS
HEATER, AND FOLLOW THESE INSTRUCTIONS.
Be sure to save this booklet for future reference.
WARNING! To reduce the risk of fire,
electric shock, or personal injury, read all
the instructions before using this heater.
--SAVE THESE INSTRUCTIONS--
IMPORTANT INSTRUCTIONS
Basic safety precautions should always be followed when using electrical products,
especially when children are present.
WARNING: TO AVOID THE RISK OF ELECTRICAL SHOCK, ALWAYS MAKE
SURE THE PRODUCT IS UNPLUGGED FROM THE ELECTRICAL OUTLET
BEFORE RELOCATING, SERVICING, OR CLEANING IT.
Read all instructions before using this heater.
This product is intended for indoor, non-commercial, non-industrial, household use
only. Do not use outdoors.
Do not use the product for any other purpose.
Never leave this product unattended while it is in use. Always turn the product to the
“OFF” position and unplug it from the electrical outlet when it is not in use.
Extreme caution is necessary when this heater is used by or near children or invalids
and whenever the heater is left operating and unattended. Keep the product out of the
reach of children and pets. This product is not intended to use by children.
Do not use the product while sleeping or place it near a person who is sleeping.
Place the product on a flat, steady, stable, heat-resistant surface.
Do not place the product on or near surfaces that may be damaged by heat (i.e.,
delicate rugs, wall paper, floor coverings not made of heat-resistant material, etc.).
Do not place this product near flammable materials, surfaces or substances (i.e.,
curtains, draperies, walls, gasoline, paint, flammable liquids, etc.), as there may be a
risk of fire.
Use the product in a well-ventilated area. .
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this heater. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the
heater and keep them away from the sides and rear.
A heater has hot and arcing or sparking parts inside.
Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
Always maintain your distance from the product while it is use to avoid serious burns
and personal injury
Never insert fingers, hair, metallic objects or any other item into the vents and
openings of the product, as an electrocution, fire, and/or burn hazard exists.
Do not insert or place flammable materials (i.e., paper, plastic, or cardboard) in, on or
near the product.
Never block the air openings of the product or place it on a soft surface (i.e., a bed or
a couch) where the air openings may be blocked. Wipe the air openings clean if they
become clogged.
Do not use this product to dry or heat clothing, shoes, pipes, or any other item.
--SAVE THESE INSTRUCTIONS--
Do not place or expose this product to water or other liquids.
This heater is not intended for use in bathrooms, laundry areas, and similar indoor
locations. Do not use this heater in the immediate surroundings of a bath, a shower or
a swimming pool.
Do not touch hot surfaces. Always use the handle of the product. Use protective
oven mitts or gloves to avoid burns or serious personal injury.
Do not move the product when it is heated. Allow the product to thoroughly cool
before handling it.
Do not run cord under carpeting and do not cover cord with throw rugs, runners or the
like. Arrange cord away from traffic area and where it will not be tripped over.
To disconnect the product, turn the controls to the “OFF” position, then remove the
plug from the electrical outlet. Disconnect the plug (do not pull on the Power Cord)
from the electrical outlet.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock, fire, or damage to the heater.
Do not use attachments not recommended or sold by the product manufacturer, as a
risk of fire, electrical shock, or serious personal injury may result.
Attachments, when furnished, may become hot during use. Allow any attachments to
cool before handling them.
To prevent a possible fire, do not block air intakes or exhaust openings in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked.
To avoid a circuit overload when using this product, do not operate another high-
wattage product on the same electrical circuit.
Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire.
Do not allow the Power Cord to hang (i.e., over the edge of a table or counter) or
place/run the Power Cord under rugs or in high-traffic areas where it may be tripped
over or pulled.
Do not put any stress on the Power Cord where it connects to the product, as the
Power Cord could fray and break.
Do not plug or unplug the product from the electrical outlet with a wet hand.
Keep the Power Cord and product away from heated surfaces.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
WARNING: In order to avoid overheating, do not cover the heater.
The heater must not be located immediately below a socket-outlet.
This heater is filled with a precise quantity of special oil. Repairs requiring opening
of the oil container are only to be made by the manufacturer or his service agent who
should be contacted if there is an oil leak.
When scrapping the heater, follow the regulations concerning the disposal of oil.
--SAVE THESE INSTRUCTIONS--
Parts Identification:
Castor Wheel Assembly
Description Drawing Quantity
Wing Nut
4
1. Castor Wheels 2. Power Switch 3. Thermostat Knob 4. Carry Handle
5. Front Cover 6. Radiator Fins 7. Cord Storage
SPECIFICATIONS
Model No. OR 9.20 OR 13.25
Power Rating 230V~ 50 Hz 230V~ 50 Hz
Wattage 2000W 2500W
Overheat protection system:
CAUTION: This product has an overheat protection system that shuts off when the
product parts become excessively hot. If the product shuts off, immediately ensure the
product has been pressed to “O” (OFF) and unplug it from the electrical outlet.
a. Remove any objects adjacent to the product that may be causing overheat conditions.
b. Do not attempt to operate the product until the overheat protection system has
permanently interrupted product operation. The overheat protection system cannot be
reset by the consumer. Do not open this product. There are no user-serviceable parts
inside.
Foot
2
Bracket
2
--SAVE THESE INSTRUCTIONS--
To assemble:
1. Turn the radiator upside-down on a soft surface (i.e., a rug), to prevent damage to the
paint finish or your floor surfacing.
2. Fit the two (2) Feet onto the radiator by placing the arc-shaped brackets between the
outermost fins on each side of the radiator.
3. Securely fasten the two (2) Feet onto the radiator by screwing two (2) Wing Nuts
onto each Foot.
CAUTION: Only operate the radiator in normal upright position with wheels and
stand assemblies attached to the bottom of the unit (wheels on the bottom, controls
on the top), any other position could create a hazardous situation
The annexation of the device’s cable is X type with special set wire way
To operate:
1. Place the product on a flat, steady, stable, heat-resistant surface.
2. Plug the Power Cord into a standard 230V AC electrical outlet.
3. Turn the thermostat knob clockwise to a position on its range.
4. Press the power switches buttons either to “I” (Low heating) or “II” (Medium heating)
or both “I+II” (High heating) position. (Fig. B)
5. Allow the heater to warm up until the ambient room temperature reaches your desired
comfort level.
Fig. B.
--SAVE THESE INSTRUCTIONS--
--SAVE THESE INSTRUCTIONS--
6. When the room reaches the desired temperature, slowly turn the thermostat knob
anticlockwise until you hear a click. This will automatically set your unit to cycle on
and off to maintain the current room temperature thermostat setting. Note: It will
normally require approx. 15 minutes to reach the operating temperature.
NOTE: The lower the thermostat setting, the lower the room temperature. The higher
the thermostat setting, the higher the room temperature.
7. To turn off the heater, press the power switches to “O” position. The power indicator
light turns off.
8. Unplug the product from the electrical outlet when it is left unattended or is not in use.
Care and Cleaning:
CAUTION: Allow the product to completely cool before handling or cleaning it.
Ensure the product is in the “O” (OFF) position and the Power Cord is unplugged from
the electrical outlet before cleaning the product.
Always ensure the product’s housing is intact and completely assembled before each
use.
Do not touch hot surfaces. Always use the handle of the product. Use protective
mitts or gloves to avoid serious burns or other personal injury.
Clean the exterior surface of the product by wiping it with a soft, damp cloth.
CAUTION: Do not allow water or other liquids to run into the interior of the product, as
this could create a fire and/or electrical hazard.
Do not use any abrasive cleaners or solvents, as product damage will occur.
Store the product in a clean, dry place when it is not in use.
Conformity with Directives
This product is CE marked to denote conformity with Directives 73/23/EEC(Low
Voltage) and 89/336/EEC (Electromagnetic Compatibility), as amended.
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

davoline OR 9.20 Safety & Operating Instructions Manual

Type
Safety & Operating Instructions Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI