Bedsure BS-HP2422 User manual

  • Hello! I am an AI chatbot trained to assist you with the Bedsure BS-HP2422 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
HEATING PAD FOR
NECK AND SHOULDER
-FOR PERSONAL USE ONLY-
IMPORTANT NOTICE
MODEL #BS-HP2422
read the entire manual carefully
before using this service
22.
3
45
Before each use, always inspect the product to ensure there is no damage to the
power cord, the Control, or the Pad.
The Pad Connector and Control Connector are designed to connect only one way.
Align the inner prongs and then push together until Connectors are touching.
check with your healthcare provider before using with a pacemaker or any medical
devices
do not plug into the wall outlet until you have connected the controller cord to the
product
CONTROLLER COMPONENTS & FUNCTION DESCRIPTION
1 - Display
2 - ON/OFF Button
3 - Time Setting Button
4 - + and - Buttons
• Turn on with the switch button, the
default level is the standby level 01,
press the "+" "-" button to regulate
the setting up to level highest 06.
• Press the time setting button, the display lasts for
2.0 hours by default, press the "+" "-" button to
adjust the timing, If there is no operation after
flashing for 3 seconds, it will return to the previously
set heating level.
Press the "+" and "-" buttons to adjust the heating level
01-02-03-04-05-06 and the timing 1.0-1.5-2.0)H.
AUTO SHUT OFF MODE
CAUTION
This product will turn o after a set duration of time. Setting times have 1.0,1.5 and
2.0 Hours
Burns can occur regardless of the control setting; check skin under Pad frequently.
Unplug the product when it is not in use.
80W
WARRANTY AND CUSTOMER SUPPORT
If you need help regarding product issues, after-sales service, or other relevant problems,
BEDSHE INTERNATIONAL CO., LTD. 20651 Golden Springs Dr., Ste. 277 Diamond Bar, CA
91789.USA
Wash by hand or as follows in automatic washer using slow agitation and normal spin
speed: Fill washer with warm water. Add minimum amount of all-purpose detergent,
agitate to dissolve, measure heating pad before washing. Add heating pad and soak ve
minutes. Agitate two minutes. Spin. Fill for cool rinse, agitate one minute then spin.
Tumble dry low., ve minutes only, or line dry. Remove damp heating pad from dryer,
block to original size, and drape to nish drying. Do not iron your heating pad.
WASHING INSTRUCTIONS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This product generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this product does cause harmful interference to radio or television
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the product and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the users authority to operate the equipment.
FCC COMPLIANT
/