Technical Specifications
Product Name
Product Model
Rated Voltage
Rated Current
Rated Power
Battery
Capacity
Gross Weight
Product Size
Input Interface
Material
：Nano Water Mist
：MAX-Q01A06RG
：DC5V
：0.5A
：1.5W
：3.7V
：25ml
：95g
：37mm x 37mm x 146mm
：Micro USB
：ABS + PC + Electronic
FAQs and Solutions
MAX-Q01A06RG
User Manual
Moisturize skin · Soothe dry skin
Product introduction:
Nano Water Mist is equipped with high-tech chip
control, producing a finer mist that quickly enters
the skin pores, reducing wrinkles, relieving skin
irritation, and also promoting skin metabolism and
improving skin pigmentation.
How to use:
* Please press the power button to turn on the
mist, and blue light indicates being in use.
With the time memory function, the Nano
Water Mist will automatically power off in 60
seconds.
* The skin without makeup is sprayed from
about 10cm, and the makeup skin should be
sprayed from around 15cm, which will not
mess up your makeup.
* Please fill in the water from the port. (Please
use mineral water)
Cleaning and Maintenance
* Before cleaning, please make sure the switch
has been turned off, and the power plug has
been pulled out from socket.
* Please use a piece of clean and soft cotton
cloth to clean this product. The cloth can be
soaked in soap water first, but please dry it to
damp before cleaning.
* Do not use corrosive cleaning agents like
benzene or thinner to clean the product,
otherwise, the color of product will fade, and
the internal parts may be corrupted or broken.
* Please keep the product away from direct
sunlight, or high temperature, to avoid fading.
* Please clean the water tank and store in a dry
place if not in use for long.
How to charge:
* Pour out all the water, and install the cap.
* Please use the equipped cable to connect the
USB port. (Android phone data cable can
replace it)
* Please don’t use the Nano Water Mist when it
was charging, extended battery life for better
usability. And please charge for 3 hours when
first time to use.
Open the
water tank
Fill water into
the water tank
Tighten
the cap
Reminder:
* Please fill with natural mineral water. If
you want to add toner or essential oil,
please add water to make a dilution
according to the ratio of 1:9.
* Please shake it before use. Must need
tighten cap after fill in the mineral water.
Then turn on the Nano Water Mist for 1
minute. Dry the mist port with tissue
when it was wet.
Issues
Product not
functioning
Product was
on but not
functioning or
the mist was
small.
Product was
leaks
Solutions
Battery is low, put on charge
immediately.
1. The water tank was out of
water, fill water into the water
tank and restart the Nano
Water Mist.
2. Battery is low, put on charge
immediately.
3. Dry with tissue when there
are leak in the mist port.
4. Clean the water tank when
there are something clogged.
Please screw the cap.
/
