Crown Automotive SC30121 Installation guide

Type
Installation guide

This manual is also suitable for

Polycanvas Rear Seat Cover Installation Instructions for 07 and Up Jeep ® JK
Wrangler
Part Numbers: SC30021, SC30121 & SC30221
Kit Contents:
1 Left Side Seat Back Cover
1 Right Side Seat Back Cover
1 Left Side Seat Bottom Cover
1 Right Side Seat Bottom Cover
2 Shoulder Belt Pads
2 Headrest Covers
NOTE: Ensure that all components in kit are accounted for.
Headrest Cover Install
1. Remove the headrests from the seats and slide the covers over them. Put headrests aside for the time being.
Rear Seat Cover Install
1. Unzip the seat back cover and pull it over the seat with the pockets facing the rear of the vehicle. Once the cover is
properly adjusted it can now be zipped up.
2. Pull the flap through the bottom of the seat cover and affix the Velcro from each end of the cover to it. The seat
buckle must be fed through this flap on the wide section of the seat.
3. Adjust as needed to achieve a proper fitment.
4. With the buckles unclipped and the straps loose, slide the seat bottom covers over the seats. Once properly
adjusted, clip the buckles around a secure point on the seat. Tighten the buckles evenly until the covers are snug
against the seats.
5. The headrests can now be re-installed.
Shoulder Belt Pad Install
1. Open the Velcro strap and wrap around the shoulder belt at the desired area and affix the Velcro.
Washing Instructions:
1. Do not machine wash. Use a mild soapy water solution to remove stains or soil. Do not use an abrasive sponge or
rub too hard on the Neoprene as it may damage the material. Let air dry.
While every attempt is made to ensure that the information contained in these instructions is correct, no liability can be accepted by the authors for loss, damage, or
injury caused by any errors in, or omissions from the information given. All service should be performed by qualified mechanics. Crown Automotive Sales Co .,Inc.
cannot be held responsible for any mechanical work performed. Standard and accepted safety precautions should be used in every procedure.
  • Page 1 1

Crown Automotive SC30121 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI