2. Nathan
  3. LightBender RX
LightBender RX

Nathan LightBender RX User manual

  • Hello! I've reviewed the user manual for the NATHAN RX light. This document provides instructions on how to operate the light, including powering on/off, cycling through colors, and changing lighting modes as well as battery charging via USB. I'm ready to answer your questions about the device.
  • How do I turn on the light?
    How do I change color?
    How do I change lighting modes?
    How do I turn off the light?
    How do I charge the device?
    How long does the light take to charge?
USAGE INSTRUCTIONS
>> Press and hold power buon for 2 – 3 seconds to turn on.
>> Once on, double-click the buon at any me to cycle through color opons.
>> Single-click the buon at any me to cycle through lighng modes.
>> Press and hold power buon for 2 – 3 seconds to turn o.
TO RECHARGE:
>> Plug supplied USB cord in to a USB power source (200mA minimum) and then plug gently
in to the covered charge port on the back of the unit. A red LED will light up to indicate
charging is occuring and a green light indicates the LightBender™ RX is fully charged.
>> Charge me is 3 hours for a fully depleted baery.
>> When fully charged, unplug LightBender™ RX from USB power supply, return port cover
gasket to original posion and store charger cord unl next use.
LightBender™ RX
/