Magma R10-1010-30 Operating instructions

Brand: Magma

Model: R10-1010-30

Category: Rack accessories

Type: Operating instructions

This manual is also suitable for

83-1010-36 0819

MAGMA PRODUCTS, INC. • 3940 Pixie Ave. • Lakewood, CA 90712 • USA • Tel: (562) 627-0500

MagmaProducts.com • [email protected]

Installation,

Care & Use Instructions

R10-1010-30 • R10-1010-36 • R10-1020

Stainless Steel Storage Arms with Foam Pads +

Protective Covers for Magma Kayak/SUP Storage Racks

CONTENTS

(2) – Stainless steel storage rack arms with foam

pads + 600D polyester protective covers

(4) – 1/4"-20 x 2" Stainless steel button socket

cap screws

(4) – 1/4"-20 Stainless steel nylock nuts

(1) – 5-/32" Hex key wrench

ADDITIONAL TOOLS REQUIRED

7/16" Wrench

INSTALLING STORAGE ARMS TO RACK

Once necessary space required between

equipment is determined, vertically

space arms accordingly. Fit attachment

bracket over vertical upright and install

(2) 1/4"-20 x 2" button socket cap screws with

(2) 1/4"-20 nylock nuts and secure using a

7/16" wrench with 5/32" hex key wrench.

NOTE: To maximize storage potential, start

installing arms from the racks top set of

holes and working down allowing minimum

space necessary between each water toy.

ADJUSTING RACK ARMS TO FIT EQUIPMENT

If additional adjustment is required to fit larger

or smaller equipment simply remove attachment

fasteners, reposition arms in the desired

location and repeat the installation procedure.

EXAMPLES OF ARM STYLES AND CONFIGURATIONS (SHOWN) OR

MIX AND MATCH TO ADAPT THE SYSTEM TO YOUR SPECIFIC REQUIREMENTS

LIMITED WARRANTY

***ORIGINAL PROOF OF PURCHASE REQUIRED FOR ALL WARRANTY CLAIMS***

Magma Products, Inc. guarantees this product to be free from defects in materials and workmanship for (1) year from the date of purchase to the original consumer. This guarantee is for the periods herein specified when used

under normal and reasonable conditions in a non-commercial or non-institutional environment. Under normal use conditions, the UV protected foam padding will withstand regular exposure to the sun’s harmful rays and is covered

by (1) year limited warranty. Tearing or ripping damage to foam padding caused by general misuse will not be covered under conditions of warranty. Additional information and full conditions of warranty visit MagmaProducts.com.

CARE & USE

• Kayak’s and SUP’s should be secured to rack when not in use

• Periodically wash rack with environmentally friendly boat soap,

fresh water, and a clean cloth to remove any debris, wipe dry

• Water toys should always be rinsed

with fresh water before storing

SECURING EQUIPMENT TO RACK

(Securing Tie-Down Straps Not Included)

• Attach hook of tie-down strap to rack’s arm

connection bracket at the main frame, extend over

equipment, and connect strap to tie-down point