Chief KONTOUR Grommet Accessory - K1D Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
dual mount
single display mount
Grommet Mounting Kit
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
KRA202
KRA202 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! The KRA202 can ONLY be mounted
onto desks measuring between 3/4" and 3 1/2" in depth!
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
DESKTOP THICKNESS
RANGE .75- 3.50" [19.1 - 88.9]
DESK BASE SHOWN
FOR CLARITY
(NOT INCLUDED)
DESK SURFACE
Installation Instructions KRA202
3
TOOLS / PARTS FOR INSTALLATION
ASSEMBLY AND INSTALLATION
1. Remove desk clamp from mount by loosening button head
cap screw until clamp is completely disengaged from the
bolt. (See Figure 1)
NOTE: Button head cap screw can be removed or left loosely
in its hole after clamp is removed.
2. Manuever clamp so that it is totally removed from desk
mount. (See Figure 1)
Figure 1
3. Locate a flat surface (thickness of 3/4" minimum to 3 1/2"
maximum) on which to mount the column plate.
4. If mounting hole does not already exist on desk, drill
mounting hole in desk at desired mounting location.
IMPORTANT ! : Mounting hole must be a minimum of
5/16" in diameter and a maximum of 2"!
5. Thread 5/16-18" hex flange nut (C) onto 5/16-18 x 5" hex
head bolt (B). (See Figure 2)
6. Position mount on desk so that threaded hole is centered
over grommet hole. (See Figure 2)
7. Insert 5/16-18 x 5" bolt (B) through grommet bracket (A),
grommet hole and thread into center hole on underside of
mount as far as possible. (See Figure 2) and (See Figure 3)
Figure 2
8. Tighten hex flange nut (C) until grommet bracket (B) is
tightened against underside of desk. (See Figure 3)
Figure 3
9. Complete the installation following the mount installation
instructions.
1/2"
(if hole needs to be created)
3/16"
(included with mount)
A (1)
[grommet
bracket]
B (1)
5/16-18 x 5"
C (1)
5/16-18"
2
1
single display mount
dual mount
5
7
7
5
(B)
(C)
(A)
(mounting arms not shown for clarity)
(mounting arms and desk not shown for clarity)
dual mount
single display mount
7
(C)
center hole
7
grommet hole
KRA202 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002072 Rev01
2011 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
10/11
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Chief KONTOUR Grommet Accessory - K1D Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI