Trailer Hitch User’s Information
MDX
2 © 2006 American Honda Motor Co., Inc. - All Rights Reserved.
Operation
How to connect connector
• Open the socket lid and insert the trailer 7-pin
connector into the socket.
• Hook the retaining tab on the inner side of the lid
against the retaining tab of the connector to
prevent disconnection during running.
• Remove the socket cover and fix it on the top of
the socket securely.
• Insert the trailer 4-pin connector into the socket
securely to prevent disconnection during running.
How to disconnect connector
• Disconnect the connectors in the reverse order
of connection.
• Do not attempt to pry off the connectors with
force.
• Close the socket lid and cover securely.
NOTE: Check for foreign material and water inside
connectors before connection. If there is any foreign
material or water inside the connector, remove it
immediately.
6401010T
LID
RETAINING
TAB
RETAINING
TAB
TRAILER 7-PIN
CONNECTOR
SOCKET
6401020T
COVER
TRAILER 4-PIN
CONNECTOR
SOCKET
© 2006 American Honda Motor Co., Inc. - All Rights Reserved. 3
• When the trailer hitch is used on a boat ramp or
in a place where the connectors are submerged
in the water, disconnect the trailer 7-pin
connector and 4-pin connector from the sockets
and close the socket lid and socket cover
securely before operation.
Failure to disconnect the connectors making the
connectors submerged in the water as a result
will cause adverse effect to the vehicle electric
system.
• Water will enter the connectors if they are
submerged in the water. Open the socket lid and
cover to drain the connectors.
Special Precautions
• Electric current flows through the positive (+)
charging circuit only when the ignition switch is in
the ON (II) position.
Using the positive charging circuit when the
engine is at a stop or during idling can discharge
the battery.
6401030T
LID
COVER
4 © 2006 American Honda Motor Co., Inc. - All Rights Reserved.
Fuse Replacement
Refer to the vehicle owner’s manual for fuse
replacement information.
The trailer can be faulty if a fuse blows out soon
after replacement. Consult with your authorized
Acura dealer.
Trailer Fuse
6401050T
Rear Fuse Box
No.
1
2
3
4
Amps.
7.5A
20A
20A
7.5A
Circuits Protected
STOP/TURN LIGHT
SMALL LIGHT
CHARGE
BACK LIGHT
Under-hood Fuse Box
6401040T
No.
13
Amps.
20A
Circuits Protected
ELEC BRAKE
© 2006 American Honda Motor Co., Inc. - All Rights Reserved. 5
Note
6 © 2006 American Honda Motor Co., Inc. - All Rights Reserved.
Note
© 2006 American Honda Motor Co., Inc. - All Rights Reserved. 7
Note
© 2006 American Honda Motor Co., Inc - All Rights Reserved. Printed in U.S.A08L91-STX-2000-81
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Acura Trailer Hitch 08L91-STX-2000-81 User Information
- Type
- User Information
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Honda Ridgeline Owner's manual
-
-
Honda Odyssey Owner's manual
-
-
-
-
-
-
-