Parts List and Wiring Diagrams
Model PH-81 Headset
Telex
.oNledoM.oNgolataC&epyTreveiceR
)smhO(ecnadepmI
&epyTenohporciM
)smhO(ecnadepmI
18-HP400-83446572,citengaM02,nobraC
.oNmetInoitpircseD.ytQ.oNtraP
1noihsuC1000-24446
2redilG1000-04446
3yssAdnabdaeH1440-26116
4piTredilS2500-66116
5recapSdnabdaeH1000-90736
7yssAredilS-ekoY-pucraE
1
1230-89307
8tiKdroC-flaHllaB-mrAmooB
2
1400-89307
9feileRniartS1500-56436
01detanimretnU,yssAdroClioC1330-25691
81lanimreT1100-26445
914/1x02-6.oN,wercS1800-65815
02paCretpadA1210-56516
12ylbmessAgnisuoH-tnemelEciM1500-89307
®
.oNmetInoitpircseD.ytQ.oNtraP
22reniateR1000-25820
32mottoBciM,gnisuoH1110-41616
42flaHllaB
3
1200-15436
52gnirpStnioJllaB1000-35436
62recapSxeH2000-70975
72reniLmaoF1000-36736
82yssAtooBtnemelErvcR-maoF1020-89307
924/1x04-4.oN,wercS2420-65815
03etalpraE1000-15736
134/1x04-4.oN,wercS2830-54815
23noihsuCraE1000-44436
33revoCnoihsuCraE1000-27753
1
One (1) slider tip (Item No. 4) is supplied with this part. Slider tip should be glued to slider using an epoxy adhesive.
2
Kit contains one (1) boom arm, one (1) boom cord, and one (1) ball half preassembled with installation instructions.
3
Quantity two (2) required per Headset, but one (1) is supplied as part of boom arm-ball half-cord kit (Item No. 8).
61171, AZ
64438, AE
64439, F
70398, A
38109-141 Rev F 10/02
Wiring Diagram
Model PH-81
/
