USAGE & CARE INSTRUCTIONS
Work Area
Do not operate power devices in explosive atmospheres, such as in the presence of
ammable liquids, gases, or dust. Power devices create sparks which may ignite the
dust or fumes.
Electrical Safety
Only recharge with the specied chargers for the battery. A charger that is suitable
for one type of battery may create risk of re when used with another battery. Use
battery operated device only with the specically designed battery pack. Use of any
other battery may create a risk of re.
Personal Safety
Stay alert, watch what you are doing, and use common sense when operating a
power device. Do not use device while tired or under the inuence of drugs, alcohol,
or medication. A moment of inattention while operating power devices may result in
serious personal injury.
• Avoid accidental spraying of device. Be sure the device is discharged before
leaving device, whether in storage, driving, or on job site.
• Do not overreach. Keep proper footing and balance at all times.
• Use safety equipment. Always wear eye protection and dust mask.
Device Use and Care
Keep device clean and in good working condition. Do not submerge in water.
Service
Device service must be performed only by qualied repair personnel. Service or
maintenance performed by unqualied personnel may result in a risk of injury and/or
electric shock. Any service not performed by Rust-Oleum approved repair personnel
will void warranty.
Safety Rules for SpraySmart
®
Marking Device
When device is charged (compressor has lled device chamber with air preparing
for release of paint) it will spray when it is held in any direction when tilt valve is
pressed. Caution is required while placing the device into the marking wand when
device is charged. Always wear safety glasses to ensure from accidental spray,
wind, etc. A mask is also recommended to ensure that paint spray is not brought
into lungs. Read paint pouch for safety requirements regarding paint itself.
Battery/Charger
Before reading battery charger, read all instructions and cautionary marking on the
(1) battery charger and (2) the product using the battery. Only use charger which
accompanied your product or direct replacement. Do not substitute any other
charger. Do not disassemble charger or operate the charger if it has been dropped
or damaged in any way. Replace damaged cords or plugs immediately. Incorrect
reassembly or damage may result in electric shock or re.
• Do not recharge battery in damp or wet environment. Do not expose charger to
rain or snow. Always check charger’s cord to ensure that there is no damage to
the cord.
• Charge device in temperatures above +40°F (4°C) and below 105°F (41°C).
Store device and battery pack in locations where temperature does not go below
40°F (4°C) and below 120°F (48°C).
• Battery leakage may occur under extreme usage or temperature conditions, or
if the device is damaged. Avoid contact with skin and eyes. The battery liquid
is caustic and could cause chemical burns. If liquid comes in contact with skin,
wash quickly with soap and water, then lemon juice or vinegar. If the liquid
contacts your eyes, ush with water for a minimum of 10 minutes and seek
medical attention immediately.
• Place charger on at non-ammable surface and away from ammable materials
when recharging battery pack. The charger and battery pack heat during
charging. Carpeting and other heat insulating surfaces block proper air circulation
which may cause overheating. If smoke or melting of the case is observed unplug
the charger immediately and do not use battery pack or charger.
Battery Care/Disposal
The battery is housed inside of device. If device is damaged and batteries are
removed or exposed, do not put batteries into re or expose to high heat—they
may explode.
• Do not attempt to disassemble the battery or remove any component. Fire
or injury may result. Prior to disposal, protect exposed terminals with heavy
insulating tape to prevent shorting.
• If device is damaged, the device and battery (lithium ion) can be disposed of in
municipal solid waste stream.
Warning-Read and understand all instructions. Failure to do so may result in electric shock, re, and/or personal injury.
SAVE THESE INSTRUCTIONS FOR REFERENCE
WARNING
Place the switch in off position before making any adjustments or
changing pouches/colors.
Operating Instructions
1. Check integrity of device and pouch to ensure that there are no leaks,
breaks, cracks, etc.
2. Remove cap from SpraySmart
®
device.
3. Massage pouch for 10 seconds and shake for 20 seconds to ensure that
paint is mixed.
4. Insert pouch into the bottom of the cap until nozzle extends through
cap opening.
5. Hold inner ring of cap and turn counter clockwise to lock cap to pouch.
6. Insert pouch into device and secure top assembly by screwing down
outer ring onto the body of the device until tight.
7. Press the power button on the bottom of the device to start the compression
of the paint pouch.
– The green “Ready” light will begin blinking.
– The device can be placed into wand as needed.
8. When green “Ready” light turns solid green the device is ready to spray paint,
even though compressor may continue to run.
9. The device will automatically pressurize and run the compressor as needed to
maintain pressure.
10. To change pouch or storage of device:
– Press the device power button to turn off.
– Release the pressure in the device by pressing the pressure relief valve
located on the cap, the release of air from the device is audible.
– Unscrew the cap by turning it counter clockwise.
– Pull cap and pouch out of the device.
– Hold pouch and turn cap counter clockwise to release the pouch
from the device cap.
– The pouch can then be stored or disposed of.
11. Charge device when battery indicator shows 1 bar. Battery indicator
will ash when battery is drained.
12. Once battery is charged, unplug the charger and remove the device.
Using Chargers:
The lithium-ion battery that powers the SpraySmart
®
device is housed inside of the
device itself. To charge the device, simply plug in the wall mount or USB and then
push the charger’s male connector into the female receptacle within the base of the
SpraySmart
®
device. The charger is working when the battery symbol on the bottom
of the device begins to blink showing the battery’s current charge level. When the
battery is fully charged, the charger should be unplugged and the device should be
removed from the charger. Always unplug chargers when they are not in use.
The charger was designed to charge the battery only when the battery is between
0° F and 105°F.
If battery does not charge properly:
1. Check for voltage at outlet by plugging in some other electrical device to
ensure that it works.
2. Check to see if outlet is connected to a light switch which turns power “off”
when lights are turned off.
3. Check charger to ensure that there is no debris or damage to the
male connector.
4. Call our customer service number: 1-800-553-8444
RUST-OLEUM SPRAYSMART
®
USAGE & CARE INSTRUCTIONS
© 2014 Rust-Oleum Corporation
/
