1.
Install
AunGdd 4-way
Dualexer
/
Salitter
a
-
IN FROM CABLE
SERVICE PROVIDER
OUT TO ROOM WITH OUT TO ADDITIONAL
WIRELESS ROUTER IAP ROOM ANTENNAS
Install 4-way DuplexerlSplitter
1.
Locate the existing CAW splitter, installed by your cable provider. This is often
found in the garage, or near where the cable enters your house, or a indoor
CATV junction box.
2.
Disconnect all cables and replace existing splitter with the AuraGrid 6way
Duplexer
I
Splitter.
3. Connect main cable enterring house to port labeled
CATV
IN.
4.
Connect the cable leading to the room where your wireless router IAP is
located to the port labeled
Room
1
1
Wireless IN.*
5.
Connect cables leading to other rooms to remaining three ports.
*TIP: How do you find the right port? First, turn on the TV in the room where your
AP is located. Next unplug the cables from the existing splitter one at a
time. When the
W
signal is lost, you have identified the cable that must be
connected
to
Room
1
1
Wireless IN.