Bauknecht KVIF 2005/A++ Program Chart

Type
Program Chart

This manual is also suitable for

A. Refrigerator compartment
1. Crisper drawer
2. Shelves / Shelf area
3. Light bulb or LEDs box (depending on model)
4. Meat/Fish compartment (if present)
5. Upper door tray
6. Door trays
7. Bottle rack
8. Bottle holder (if provided)
9. Rating plate (at the side of crisper drawer)
10. Electronic control group
B. Freezer compartment
1. Ice cube tray (inside compartment)
2. Freezer compartment inner door
Note: The number of shelves and type of accessories may vary, depending on the model.
All shelves, door trays and racks are removable.
Important: Refrigerator accessories must not be washed in a dishwasher.
The meat/fish compartment lid must not be washed with water but cleaned with a damp sponge.
PRODUCT SHEET
GB
1
9
4
2
3
A
1
2
B
6
5
8
7
10
3
D INLFGB
A. Temperature adjustment key (change the
temperature setting in a cyclical manner)
B. Appliance on/off switch
C. Set temperature display LED:
LED 1: lowest temperature
LED 2 or 3: intermediate temperature
LED 4: highest temperature
All LEDs on: fast cooling function active
We recommend to set the temperature to an
intermediate position
The refrigerator is designed to operate at ambient
temperatures between +10°C and +32°C.
Optimum performance is achieved at
temperatures between +16°C and +32°C.
Note: Ambient temperature, frequency of door
opening and position of the appliance can affect the
temperatures inside the refrigerator, and therefore
also those of the meat & fish compartment. It is
therefore recommended that the temperature
setting is adjusted based on these factors.
REFRIGERATOR COMPARTMENT
CONTROLS
AB
C
led 1led 2led 3led 4
Always disconnect the refrigerator from the power
supply before replacing any light bulb. If the inside
light is not working, it is necessary to:
1. Remove the light cover: put the fingers into the
side ventilation holes (1), stretch the cover
gently and move it upwards.
2. Remove the bulb pulling it out of the holder (do
not rotate).
3. Check the bulb and replace (if necessary) by
pushing its terminals into the holder sockets
until it stops.
4. Replace the light cover or holder.
The appliance is equipped with a special push-in
light bulb.
This bulb is available only from our After-Sales
Service.
The bulb should not exceed 15W.
Do not leave uncovered the bulb.
REPLACING THE LIGHT BULB
INLFGBD
5019 100 01101
Printed in Italy 10/08
  • Page 1 1
  • Page 2 2

Bauknecht KVIF 2005/A++ Program Chart

Type
Program Chart
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI