Bauknecht GMI 5554 Program Chart

Brand: Bauknecht

Model: GMI 5554

Type: Program Chart

This manual is also suitable for

GMI 5554/1 IN

The Bauknecht GMI 5554/1 IN dishwasher offers a range of features to make dishwashing easier and more efficient. With its half load function, you can save water and energy when washing smaller loads, and the antibacterial rinse option ensures that your dishes are hygienically clean. The adjustable racks and cutlery basket allow you to customize the dishwasher to fit your needs, and the delayed start function lets you program the dishwasher to start washing at a time that's convenient for you.

5019 496 96031

Quick Reference Guide

Before using the dishwasher, read the user instructions!

(We reserve the right to make technical modifications)

GMI5554/1

Add regeneration salt

Only add regeneration salt immediately before

starting a wash programme.

Add rinse aid

Antebacterial rinse (Sani-Rinse option)

This function executes an antibacterial rinse at the

end of the wash cycle, thereby further reducing

bacteria levels. The lamp will light up when the

function is activated. If the temperature is not

maintained during the antibacterial cycle

(e.g. if the door is opened or a power failure

occurs), the lamps will start blinking to indicate

that the antibacterial action is not guaranteed.

Half load function

Recommended when the dishwasher is not full to

save water and electricity. Press the button to

wash the top rack. Press the button to wash the

bottom rack. Press the button again to deactivate

the function. The indicator light and display show

that only one rack is selected.

WARNING:

This function remains selected until

switched off.

“Delayed start” button

The wash cycle can be programmed to start after

1-12 hours. Then press the Start button. After a

prewash the set delay will start.

Display

The display shows all the information relating to

the selected functions and the indication about all

functional failures (see table on the “Instructions

for Use” manual).

1) Reference programme for energy label in compliance with

EN 50242;

2) Programme data obtained in conformity with European standard

EN 50242. Values may vary in relation to usage, e.g.: different loads,

water temperatures - above or below 15° C - as well as water

hardness and power supply voltage, etc.

Programme ON/OFF selector knob

First press and release the selector knob to access it,

and then turn it to select the desired programme;

the dishwasher switches on.

To switch off the dishwasher when the programme

has finished, turn the selector knob to off.

Start button

Press to start the wash cycle and keep pressed until

an acoustic signal confirms the start of the wash

cycle. The display shows the approximate duration

of the wash cycle.

Note:

the light above the start button blinks during

the wash cycle.

The light stops blinking and remains alight to indicate

the cycle has ended (“End” on the display) or has

been interrupted due to a fault (“E1, E2....” on the

display).

Indicators

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions

A B Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 6.0 0.02 15

Rapid 30 min 45°C

Lightly soiled crockery with no dried-on

food.

X - 13.0 0.80 45

Bio

55°C

Normally soiled crockery. X - 15.0 1.08 180

Normal 65°C

Normally or heavily soiled crockery. X - 17.0 1.28 90

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for pans

and saucepans.

X X 20.0 1.60 110

49696031GB.fm Page 1 Monday, August 24, 2009 7:34 PM

Black process 45.0° 150.0 LPI

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Large compartment

Small compartment

Mechanical indicator lamp

Electric indicator on control panel (if provided).

On models with water softener system

only.

Mechanical indicator lamp

Electric indicator on control panel

(if provided).

Refer to the dishwasher loading instructions.

Press and turn the selector knob to select the desired programme and

switch on the appliance.

If necessary (and if provided).

The corresponding indicator lamp lights up.

“Cancel”

Press and hold the “Start” button

until the indicator lamp stops

blinking and stays on.

Press and hold the “Start” button

for 10 seconds. “P0” will appear on

the display and the programme will

stop.

“Change programme in

progress”

Press and hold the “Start” button

until the indicator lamp stops blinking

and stays on.

Select and start the programme as

described previously.

- Only open the dishwasher if

necessary (Warning: beware of

hot steam).

- If the appliance is switched off

during a wash cycle, when

switched on again it will resume

the cycle from where it was

interrupted.

To switch off the dishwasher turn the selector knob to off.

All the indicator lamps and the display switch off.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

Open the door

How to fill the

detergent dispenser

Check the rinse aid level

Check the

regeneration salt level

Load the racks

Close the door,

select a programme

Select

additional options

Turn on the water tap

Press the Start button

to start the programme

(during the cycle the

Start indicator blinks)

Wash cycle

Switch off the appliance

Turn off the water

tap, unload the racks

49696031GB.fm Page 2 Monday, August 24, 2009 7:34 PM

Black process 45.0° 150.0 LPI

Dishwasher loading instructions and racks provided

Upper rack:

depending on the model

Cup holders (A):

Depending on the position, up or down.

Place the glasses in the middle and to

the right, dishes to the left, under the

cup holder grids.

Place long and narrow utensils

(carving forks, knives) on the

bottom of the rack, not crosswise,

with the sharp ends facing towards

the appliance.

Cutlery basket supports (B):

Raised or lowered, depending on the

position.

Vertical adjustment of

basket (also with basket

loaded):

Pull upwards to the first or second

catch to raise the basket.

Pull the side release lever to lower the

basket.

The rack must be level on both

sides.

Lower rack:

With tilting plate holders.

Cutlery basket:

It is equipped with grill elements (

) to

keep the cultery separated. It can be

divided into two parts, which is handy

for half-load washes or when there are

just a few pieces of cultery to be

washed.

Objects that can cause injuries

must be arranged in the rack with

tips facing downwards.

Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a

dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed),

silver cutlery.

ABAB

Release lever

49696031GB.fm Page 3 Monday, August 24, 2009 7:34 PM

Black process 45.0° 150.0 LPI

What to do if...

If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see

also the corresponding chapter in the user instructions).

Problem Cause Remedy

The appliance is not

working

• No water supply. • Open the tap.

• The appliance does not load sufficient

water.

• Clean the water supply tap filter.

• Ensure there are no kinks in the water hose.

• There is a power failure. • Insert the plug into the mains socket.

•Open the door.

•Close the door.

• Check the domestic circuit fuse.

If crockery is not

perfectly dry

• Insufficient rinse aid. •Increase dosage *.

• Residual water in cavities. • Load crockery at an angle.

If crockery is not

perfectly clean

• The water jet does not reach the

crockery.

• Arrange crockery so that items do not touch each other.

Load crockery upside down.

• Insufficient detergent. • Follow recommended detergent dosage.

• Unsuitable programme. • Select a more intense wash cycle.

• Spray arms blocked. • The spray arms must be able to turn freely.

• Spray arm nozzles clogged. • Remove any impurities obstructing the water flow *.

• Incorrect detergent/detergent too old. • Use a good quality detergent.

Sandy or grainy

residues

• Clogged filters. • Check filters regularly/if necessary clean *.

• Filters incorrectly assembled. • Insert the filter correctly *.

Colour of plastic parts

faded

• Tomato/carrot juice,... • Depending on the material, if necessary use a

detergent with a greater whitening power.

Deposits on crockery

•removable • Streaks on the crockery/glasses. • Reduce the rinse aid dosage *.

• Layer of salt on crockery/glasses. • Close the salt container lid properly *.

• not removable • Insufficient water softening, calcium

deposits.

• Change water hardness setting, if necessary add salt *.

Opaque glasses/

glasses not sparkling

• Cannot be washed in the dishwasher. • Use suitable glasses.

Rust on cutlery

• Not made of stainless steel. •Use suitable cutlery.

If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water

supply tap, then call our After-Sales Service (see guarantee).

Before contacting our After-Sales Service, take note of the following:

• The nature of the fault.

• The appliance type and model.

• The service code (the number indicated on the adhesive rating plate)

inside the door on the right-hand side.

49696031GB.fm Page 4 Monday, August 24, 2009 7:34 PM

Black process 45.0° 150.0 LPI

Bauknecht GMI 5554 Program Chart

Brand: Bauknecht

Model: GMI 5554

Type: Program Chart

This manual is also suitable for

GMI 5554/1 IN

Download PDF

report

Bauknecht GMI 5554 Program Chart

This manual is also suitable for

Bauknecht GMI 5554 Program Chart

Related papers

Other documents