Unbranded R6GN Installation guide

R6GN
Unbranded
Brand
Unbranded
Model
R6GN
Type
Installation guide

This manual is also suitable for

INSTALLATION
INSTRUCTION
INSTALLATION INSTRUCTIONS FOR
555633
MOTORIZED (OAD) OUTSIDE AIR DAMPER USED WITH
GR4GM 150/180 UNITS
SUPERSEDES 10-22-04
AUGUST 26, 2008
NEI35MA10
Figure 1
CONTROL MOTOR
WIRE HARNESS
FORM# 655B-0808 (655B-0504)
DAMPER SECTION
MOUNTING HOLES
(STEP 3)
OAD PANEL REMOVED FROM UNIT
OAD SLIDE DAMPERS
Note: 919275 Fresh Air hood is re quired
I - SHIP PING AND PACK ING LIST
Package 1 of 1 contains:
1 - Damper Section with Motor
6 - Screws 10 x ½ x 16 Hex Tex
Check contents for shipping damage. Contact the last carrier
immediately if any shipping damage is found.
II - AP PLI CA TION
The Outside Air Dampers (OAD) are designed to fit the Return
Access Panel. The motorized dampers use a 2-position motor that
opens when blower is energized.
III - IN STAL LA TION
DIS CON NECT ALL ELEC TRI CAL POWER TO THE UNIT
BE FORE SER VIC ING.
1. Remove fresh air hood and OAD panel from unit.
2. Remove OAD slide dampers and set to side for later use.
3. Align damper section to mounting holes in OAD panel and
secure using screws provided on this kit. See Figure 2.
4. Replace OAD slide dampers in desired position.
5. Place OAD Panel back in same place unit panel was located.
Connect (P1) plug from OAD to (S1) economizer plug on unit.
6. Replace fresh air hood over OAD panel and secure using
screws removed in Step 1. Seal any corners, clearance holes,
etc. to ensure a watertight seal.
7. Restore all electrical power to the unit.
8. Check proper operation of the Outside Air Damper by
energizing the indoor blower motor. Ensure wire harness is
secured out of the way and dampers operate when 24V power
is supplied.
Figure 2
WIRE COLOR CODE
BLK Black
RED Red
0-35% Mo tor ized Out side Air Damper
for GR4GM 150-180
555633
Notes:
1. Unit wir ing shown as ref er ence only. Check unit wir ing for ac tual unit wir ing.
Date: August 26, 2008
Supercedes: 09-30-04
Drawn by:
Unit # 47-287-10
Dia gram# 28710W
HARNESS DETAIL
E# = WIRE END DESIGNATION
E2 STUD #6 18 Ga. Wire
E3 Female ¼ Quick Disc.
E4 Male ¼ Quick Disc. Insul
E6 Wire Nut Size 73B
HAR NESS ENDS AT
(P1) FRESH AIR PLUG
COMPONENT CODE
Economizer
M8405A Damper Actuator 24V
P1 OAD Plug
S1 Unit Economizer Plug
CONNECTOR & CONTACT CONFIGURATION
P1 (303908) PLUG - (303912) PIN
© Nortek Global HVAC,
LLC 2015. All Rights Reserved.
  • Page 1 1
  • Page 2 2

Unbranded R6GN Installation guide

R6GN
Unbranded
Brand
Unbranded
Model
R6GN
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents