Minka Group 6393-77 User manual

Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
Item#6394 (New. 04/03/2013)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 3
Fig. 4
Fig. 2
PREPARATION (Fig.1)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture, including the
mounting hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration. Prior to installing glass, remove screws
(G) and metal frame (H) from fixture body (C).
3. Attach the Mounting Plate (A) to the Junction Box
using Junction Box Screws (B). The side of the
mounting plate marked “GND” must face out.
MOUNTING THE FIXTURE (Fig.2 & 4)
4. Place the Allen screw (N) over the Plastic Washer
(O), Diffuser Glass Shade (P) and Metal Plate (Q)
secure with Metal Frame (H), then place the Screw
(L) through the Plastic Washer (K), Glass Panel (M)
and Metal Plate (I) secure with Metal Frame (H).
5. Install the Xenon bulb (included) in accordance with
the fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
6. Secure the Metal Frame (H) onto the Fixture Body
(C) by using Screws (G).
CONNECTING THE WIRES (Fig. 3)
7. At this point, connect the electrical wires as shown in
Fig. 3, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s Ground Wire to
it. Otherwise, connect the fixture’s Ground Wire
directly to the mounting plate using the Green Screw
provided. After wires are connected, tuck them
carefully inside the Junction Box.
FINISHING THE INSTALLATION (Fig.4)
8. Place Fixture Body (C) over Mounting Plate (A),
fasten with Screws (D) by using Allen Wrench (R)
provided.
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-1917E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
H
L
N
Q
P
M
O
K
J
I
A
B
D
G
H
C
R
Outlet Box
Outlet Box
A
B
E
G
H
D
C
F
  • Page 1 1

Minka Group 6393-77 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI