Lenmar BCR-467 User manual

Lenmar
Brand
Lenmar
Model
BCR-467
Category
Battery chargers
Type
User manual

This manual is also suitable for

OPERATING INSTRUCTIONS
OmniSource
®
467 - MODEL BCR467
INTRODUCTION
Thank you for purchasing LENMAR’s OmniSource 467, model BCR467. With it you can charge AA, AAA
and virtually all 4.8, 6, 7.2, 9.6 or 10 Volt camcorder batteries. This charger is compatible with Nickel
Cadmium, Lead Acid, Lithium-Ion, Nickel-Metal Hydride, and NoMEM® batteries. The BCR467 will operate
as an AC/DC Battery Charger and Reconditioner.
The OmniSource 467 will operate from a standard household AC outlet, or on the road from a 12 Volt
cigarette lighter socket. It is a complete, convenient system to refresh, condition, and charge almost any of
your rechargeable batteries.
Getting Ready...
CONNECTING THE POWER SUPPLY
To charge or discharge batteries, either the AC Adapter or the DC Automotive Adapter must be plugged into
the jack marked "DC INPUT" on the Base Module. Once you have done this, plug the power adapter into an
AC receptacle or cigarette lighter (depending on which adapter you are using).
If You Have...
Nickel Cadmium (Ni-Cd) Batteries
When you recharge a nickel-cadmium battery before it's fully drained, the battery "remembers" it is using
less than a full charge, resulting in a loss of capacity. Because of this, the BCR467 has a Discharge /
Charge feature which will automatically discharge your Ni-Cd battery and then charge it fully. Doing this will
assure that you will get the maximum life out of your Ni-Cd batteries.
NoMEM, Lithium-Ion (Li-Ion), Nickel-Metal Hydride (Ni-MH), and Lead Acid (Pb) Batteries
These types of batteries do not have a problem with "Memory". Be sure to follow the recommended charging
and storage instructions for the battery type you are using.
Using Your OmniSource 467
CHARGE MODE (for all battery types)
Plug the appropriate adapter into the proper power source (either a household AC outlet or 12 Volt Car
cigarette lighter) and plug the other end into the charger base module connector marked DC 12-18V INPUT.
Insert the battery into the proper charging slot (see diagram for proper battery location).
1. DC Power Input Jack - AC
Adaptor or Car Cigarette
Lighter Adaptor
4. JVC/Panasonic
/Hitachi/RCA 9.6 / 10V Batt
7. Panasonic/Sony/Hitachi
/JVC/RCA 4.8/6V Batt.
2. Sony 7.2 Volt Li-Ion
Battery
5. AA / AAA Battery (x4) 8. Adjustable Sliding Plate
3. Charge Indicator 6. Canon 6VBattery 9. Discharge Button
The charger unit will beep once to verify the battery is making proper contact and will begin to charge the
battery. The charge indicator on the side of the unit will show the progress of the charge.
mll ð mml ð mmm ð llm
0-33% 33-66% 66-99% Full
( l = OFF m = ON )
The charger will automatically stop the charge and beep 3 times when a full charge is detected on the
battery. The charge indicator will show only 1 Red light to indicate the battery has reached full charge. The
time required to reach a full charge will vary depending on the capacity of the battery and how much charge
is already in it before you start.
NOTE
: Due to the special properties of Li-Ion batteries, the charge indicator may not accurately indicate the
actual status of the battery as it charges and the charger may seem to be turning on and off by itself after
the battery has reached a full charge. When this happens, the battery is ready for use, and should be
removed.
DISCHARGE / CHARGE MODE (for Ni-Cd type batteries)
Plug the appropriate adapter into the base module, and insert the battery to be charged. Once the charger
beeps to indicate that the battery is properly connected, press the Discharge button on the side of the unit.
The unit will beep 2 times and the green Discharge light will go on. The DISCHARGE light will stay on until
the battery is fully discharged, then the charger will switch automatically into the charge mode and charge
the battery fully.
NOTE: You should only use the Discharge feature with a Ni-Cd type battery. Discharging other type
batteries may cause damage.
SPECIFICATIONS:
P
P
O
O
W
W
E
E
R
R
S
S
O
O
U
U
R
R
C
C
E
E
· AC Adapter - Output 14 VDC - 800mA, UL/CSA Approved
· 12 Volt DC Cigarette Adapter - Not to exceed 18 VDC
C
C
H
H
A
A
R
R
G
G
I
I
N
N
G
G
C
C
I
I
R
R
C
C
U
U
I
I
T
T
· Microprocessor Controlled Compatible with Ni-Cd, Ni-MH, Li-Ion, Lead Acid, NoMEM
· AutomaticVolt. Select. (4.8V / 6V / 7.2V / 9.6V/10V)
· Current: AA/AAA type - 200mA, Sony 7.2V NP-500 type - 200mA, others - 780mA
· Detection: -DV (50mV) & DT (room temp. +10°C)
· Protection: Max. Voltage, Time, and Temperature
D
D
I
I
S
S
C
C
H
H
A
A
R
R
G
G
I
I
N
N
G
G
M
M
O
O
D
D
E
E
· Current - 400-450mA, Cut Off - 1V / Cell
B
B
a
a
t
t
t
t
e
e
r
r
y
y
C
C
o
o
m
m
p
p
a
a
t
t
a
a
b
b
i
i
l
l
i
i
t
t
y
y
Charging Slot * Battery Type Accepted **
Location 2 Sony - 7.2 Volt Li-Ion type
Location 4 Panasonic / JVC / Rca / Hitachi -
9.6/10 Volt types
Location 5 AA (UM-3), AAA (UM-4) Ni-Cd (4
batteries of same type required)
Location 6 Canon - All 6 Volt types
Location 7(plate (8) up) Panasonic / JVC / Sony / Rca / Hitachi
/ Nikon / Minolta / Ricoh - 6 Volt
types
Location 7(plate (8) down) Panasonic - 4.8 Volt types
*See diagram on previous page ** May fit additional makes and models
T
T
h
h
e
e
f
f
o
o
l
l
l
l
o
o
w
w
i
i
n
n
g
g
s
s
t
t
a
a
t
t
e
e
m
m
e
e
n
n
t
t
i
i
s
s
r
r
e
e
q
q
u
u
i
i
r
r
e
e
d
d
i
i
n
n
t
t
h
h
e
e
s
s
t
t
a
a
t
t
e
e
o
o
f
f
C
C
a
a
l
l
i
i
f
f
o
o
r
r
n
n
i
i
a
a
p
p
u
u
r
r
s
s
u
u
a
a
n
n
t
t
t
t
o
o
t
t
h
h
e
e
s
s
e
e
t
t
t
t
l
l
e
e
m
m
e
e
n
n
t
t
o
o
f
f
a
a
n
n
a
a
c
c
t
t
i
i
o
o
n
n
b
b
r
r
o
o
u
u
g
g
h
h
t
t
b
b
y
y
t
t
h
h
e
e
M
M
a
a
t
t
e
e
e
e
l
l
E
E
n
n
v
v
i
i
r
r
o
o
n
n
m
m
e
e
n
n
t
t
a
a
l
l
J
J
u
u
s
s
t
t
i
i
c
c
e
e
F
F
o
o
u
u
n
n
d
d
a
a
t
t
i
i
o
o
n
n
a
a
g
g
a
a
i
i
n
n
s
s
t
t
m
m
u
u
l
l
t
t
i
i
p
p
l
l
e
e
e
e
l
l
e
e
c
c
t
t
r
r
o
o
n
n
i
i
c
c
s
s
a
a
n
n
d
d
a
a
p
p
p
p
l
l
i
i
a
a
n
n
c
c
e
e
m
m
a
a
n
n
u
u
f
f
a
a
c
c
t
t
u
u
r
r
e
e
r
r
s
s
.
.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
:
:
H
H
a
a
n
n
d
d
l
l
i
i
n
n
g
g
t
t
h
h
e
e
c
c
o
o
r
r
d
d
o
o
n
n
t
t
h
h
i
i
s
s
p
p
r
r
o
o
d
d
u
u
c
c
t
t
w
w
i
i
l
l
l
l
e
e
x
x
p
p
o
o
s
s
e
e
y
y
o
o
u
u
t
t
o
o
l
l
e
e
a
a
d
d
,
,
a
a
c
c
h
h
e
e
m
m
i
i
c
c
a
a
l
l
k
k
n
n
o
o
w
w
n
n
t
t
o
o
t
t
h
h
e
e
s
s
t
t
a
a
t
t
e
e
o
o
f
f
C
C
a
a
l
l
i
i
f
f
o
o
r
r
n
n
i
i
a
a
t
t
o
o
c
c
a
a
u
u
s
s
e
e
b
b
i
i
r
r
t
t
h
h
d
d
e
e
f
f
e
e
c
c
t
t
s
s
o
o
r
r
o
o
t
t
h
h
e
e
r
r
r
r
e
e
p
p
r
r
o
o
d
d
u
u
c
c
t
t
i
i
v
v
e
e
h
h
a
a
r
r
m
m
.
.
W
W
a
a
s
s
h
h
h
h
a
a
n
n
d
d
s
s
a
a
f
f
t
t
e
e
r
r
h
h
a
a
n
n
d
d
l
l
i
i
n
n
g
g
.
.
LIMITED 3 YEAR WARRANTY
This limited warranty starts from the date of original purchase and expires 3 years
thereafter.
If, during this period, any part, because of manufacturing defects or workmanship fails to
function properly under normal use will be repaired at no charge for parts and labor or,
at our option, the product will be replaced. The following is excluded: damages from
delay or loss of use of equipment, or damaged batteries, malfunctions resulting from
misuse, tampering, unauthorized repairs, modifications, or accident.
Package the unit and its accessories carefully using ample padding material to prevent
damage in transit and ship it prepaid and insured to:
LENMAR ENTERPRISES INC. USA , 4035 Via Pescador, Camarillo, CA 93012
When sending in product for service, your package should include evidence of date and
place of purchase. Enclose $10.00 for shipping and handling for addresses in the U.S.
For outside the U.S. and Canada, freight will vary depending upon ship to address.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Lenmar BCR-467 User manual

Lenmar
Brand
Lenmar
Model
BCR-467
Category
Battery chargers
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents