Whirlpool DP-009 User manual

Whirlpool
Brand
Whirlpool
Model
DP-009
Type
User manual

Whirlpool DP-009 is a versatile device that allows you to change the exhaust blower position of your new Microwave Hood Combination (MHC). With two recessed screws located in the holes below the blower assembly, you can easily rotate the blower to the desired position - top discharge or rear discharge. This flexibility ensures efficient ventilation in your kitchen, whether you prefer to vent the air upwards or towards the back.

Remember to disconnect the wiring harness plug before rotating the blower assembly for added safety.

Whirlpool DP-009 is a versatile device that allows you to change the exhaust blower position of your new Microwave Hood Combination (MHC). With two recessed screws located in the holes below the blower assembly, you can easily rotate the blower to the desired position - top discharge or rear discharge. This flexibility ensures efficient ventilation in your kitchen, whether you prefer to vent the air upwards or towards the back.

Remember to disconnect the wiring harness plug before rotating the blower assembly for added safety.

Delivery & Installation Pointer
September 2006
Exhaust Blower Change
New Microwave Hood Combination
(MHC)
(Whirlpool Brand)
DP-009
September 2006
8178602
The newly designed MHC is shipped with the exhaust blower in the recirculation
position. The blower can be rotated for a top discharge or rear discharge by removing
the 2 recessed screws on the rear of the MHC. The 2 visible gold colored screws
under the blower housing are being removed in error.
Procedure to reverse the blower assembly.
1. Locate the 2 screws that loosen the blower assembly. The screws are located in
the holes below the blower assembly (See Figure A.)
BACKGROUND:
ISSUE:
2. Removing the 2 screws will require either a hand screwdriver or a longer phillips
bit for your drill. These screws are recessed into the hole approximately ¾”.
3. Remove the blower assembly and rotate to the desired position. When rotating the
blower it is best to disconnect the wiring harness plug before rotating the blower
assembly. After repositioning the blower reinstall the wiring harness plug.
4. Do not to overtighten the 2 blower screws when reinstalling.
RECESSED SCREWS
DO NOT REMOVE
THESE SCREWS
FIGURE A
Page is loading ...
  • Page 1 1
  • Page 2 2

Whirlpool DP-009 User manual

Whirlpool
Brand
Whirlpool
Model
DP-009
Type
User manual

Whirlpool DP-009 is a versatile device that allows you to change the exhaust blower position of your new Microwave Hood Combination (MHC). With two recessed screws located in the holes below the blower assembly, you can easily rotate the blower to the desired position - top discharge or rear discharge. This flexibility ensures efficient ventilation in your kitchen, whether you prefer to vent the air upwards or towards the back.

Remember to disconnect the wiring harness plug before rotating the blower assembly for added safety.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Other documents