Epicureanist EP-SHOT001 User guide

Epicureanist LLC, 16782 Von Karman Ave., Suite 15, Irvine, CA 92606

Ice Shooters Tray

INS TRUC T IONS FOR US E

Remove lids from each Ice Shooter mould cup.

Fill cup ¾ from the top with water or other non -alcoholic

beverage.

Carefully replace lid on the cup.

Place filled mould into a freezer for at least 5-6 hours. For

best results, place on a flat, level surface.

Remove Ice Shooter mould from freezer.

To remove Ice Shooter from mould: Run room temperature

water over the outside of the mould (not inside) to loosen the

frozen Ice Shooter. NOTE: Using hot or warm water will melt

the Ice Shooters.

PR E CAUT IO NS

It is recommended that the Ice Shooter be removed from the freezer and

mould just a few minutes before use.

To reduce melting, it is best to pour a chilled beverage into the Ice

Shooter.

Attempting to remove Ice Shooters from mould without applying water to

the outside of the cup will cause the ice to crack during removal.

SERVICE & IMPORTANT NOTICE:

The manufacturer has a policy of continuous improvement on its products and reserves the right

to change materials and specifications without notice.

Epicureanist is a trademark of Epicureanist LLC. All products, features, and services are subject to

change without notice. We cannot guarantee the accuracy of the contents of this document. We

disclaim liability for errors, omissions, or future changes.

Download PDF