Minka Lavery 6562-77 Installation guide

Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTION FOR FIXTURE
6562-776563-77 6564-77
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT OFF THE POWER AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE
1. Shut off the power supply at the fuse box or circuit
breaker box. Remove the old fixture from wall.
Including the old cross bar.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to lose any small
parts necessary for installation.
3. Thread the mounting screw (C) into the mounting
holes on the mounting plate (A) well and secure with
hex nut (D).
4. Attach the mounting plate (A) to the outlet box using
the outlet box screws(B). The side of the mounting bar
marked “GND” must face out.
5. Follow the wiring instructions carefully (See Fig.2).
6. Attach the fixture back plate(J) over the mounting
plate (A) by protruding the mounting screw(C) through
the mounting hole of the back plate(J) and secure with
nut(I).
7. Put the glass shade (G) over the socket (H) and
secure with socket ring (F).
8. Install the bulb in accordance with fixture’s
specifications. DO NOT EXCEED THE MAXMUM
WATTAGE RATING!
Your installation is now complete. Return power to the
juction box and test the fixture.
Wiring (See fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black (HOT) house
wire. Connect the white wire from the fixture to the
white (Neutral) house wire. Make sure all the wire
nuts were secured. You may wrap the connections
with electrical tape. If your outlet box has a ground
wire (Green or Bare Copper) connect fixture’s
ground wire to it. Other wise attach the bare copper
fixture wire to the green ground screw on the
mounting plate.
2. Tuck the wire connections neatly into the wall
junction box.
S
O
C
K
E
T
R
I
N
G
(
F
)
G
L
A
S
S
S
H
A
D
E
(
G
)
S
O
C
K
E
T
(
H
)
H
E
X
N
U
T
(
D
)
G
R
O
U
N
D
W
I
R
E
G
R
E
E
N
G
R
O
U
N
D
S
C
R
E
W
(
C
)
M
O
U
N
T
I
N
G
S
C
R
E
W
W
I
R
E
N
U
T
S
U
P
P
L
Y
W
I
R
E
O
U
T
L
E
T
B
O
X
(
B
)
O
U
T
L
E
T
B
O
X
S
C
R
E
W
S
(
A
)
M
O
U
N
T
I
N
G
P
L
A
T
E
B
A
C
K
P
L
A
T
E
(
J
)
N
U
T
(
I
)
Fig.2
Fig.1
  • Page 1 1

Minka Lavery 6562-77 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI