2. INSTEON
  3. Remote Control Dual On/Off Outlet

INSTEON Remote Control Dual On/Off Outlet, Refurbished Remote Control Dual On/Off Outlet Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the INSTEON Remote Control Dual On/Off Outlet Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTEON On/O Dual-Outlet
Quick Start Guide
INSTEON On/O Dual-Outlet
For the complete Owner’s Manual and
more, visit: insteon.com/support
Lower
Outlet
Tamper
Resistant
Upper
Outlet
Tamper
Resistant
Status
LEDs
On/O &
Set Buttons
Phillips Screwdriver
Tools Needed for Installation
Wire Cutter / Stripper
Voltage Detector
Flathead Screwdriver
Disconnect Power
Always disconnect power before
installation. Contact INSTEON
Support when uncertain about
installation.
1-866-243-8022
Basic Installation
1
ON
ON
ON
ON
ON
ON
ON
OFF
ON ON
Turn o power to your outlet at the
electrical service panel.
Circuit Breakers Fuse Panel
or
Power is ON Power is OFF
2
Remove the old outlet and disconnect
the wires. Be sure there is about ½ inch
of bare wire showing.
½”
1 2
3
Turn on power at the circuit breaker
and use a voltage detector to carefully
identify line and neutral. Line will be
energized.
4
Turn o power at the circuit breaker. Connect the Outlet wires to the identied wires in the
junction box. Verify that the wire nuts are secure and that no exposed copper wire is visible
except for the bare ground wire.
Line
Turn o power at the circuit breaker. Connect the Outlet wires to the identied wires in the
junction box. Verify that the wire nuts are secure and that no exposed copper wire is visible
except for the bare ground wire.
Neutral
Line
Ground
5
Mount the Outlet into the junction box
and turn power on to the outlet at the
circuit breaker panel.
6
Ensure your appliance is on and test
your On/O Outlet by tapping one of the
two set buttons. Your appliance will turn
on and o.
Installation complete. You can now add
your On/O Dual-Outlet to the Hub.
Follow the on-screen instructions to add your
On/O Dual-Outlet to the INSTEON Hub.
Linking to the Hub
+
When prompted, press and hold one of
the set buttons on the On/O Dual-Outlet.
If not using the Hub, refer to the
instructions that came with your product.
!
On/Off Outlet
Turn on, turn o, set schedules and create
scenes for your On/O Dual-Outlet using the
INSTEON Hub and App.
Device Control
Rev 10.29.14
Protected under U.S. and foreign patents (see www.insteon.com/patents)
©2014 INSTEON
/