EN
3
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal.
Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours.
Remove any protective cardboard or transparent film
from the oven and remove any accessories from inside
it.
Heat the oven to 250°C for about one hour, preferably
using the “Convection Bake” function. The oven must
be empty during this time.
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the rst time.
USING THE APPLIANCE FOR THE FIRST TIME
1. SELECT A FUNCTION
To select a function, turn the selection knob to the
symbol for the function you require.
2. ACTIVATE A FUNCTION
To start the function you have selected, turn the
thermostat knob to set the temperature you require.
To interrupt the function at any time, switch o the
oven, turn the selection knob and the thermostat knob
to to
and .
3. PREHEATING
Once the function has been activated, the LED
thermostat will switch on signalling that the
preheating process has begun.
At the end of this process, the LED thermostat
switches off indicating that the oven has reached the
set temperature: at this point, place the food inside
and proceed with cooking.
Please note: Placing the food in the oven before preheating
has nished may have an adverse eect on the nal cooking
result.
• COOKTOP OPERATION
(see the instructions supplied with the cooktop)
Turn the control knob of the relevant hotplate
clockwise to the desired power setting.
The oven control panel features 4 adjustable knobs
for cooktop operation. The cooktop control knobs
are marked with a numerical scale corresponding
to different power settings, and a series of function
symbols.
GENTLE HEAT
To allow dough to rise, to soften butter taken
from the fridge, to keep baby bottles or food warm,
also for making yoghurt, melting chocolate, etc.
This function is only available when the residual
heat indicator is on. For this function, make sure the
residual heat indicator of the desired hotplate is on.
Turn the knob to
. To deselect the function, change
the position of the knob.
HEAT MAINTENANCE
To maintain a constant temperature of 60° until
the end of cooking. To select this function, turn the
knob to
.
FAST BOIL
This function is used to bring water to the boil
rapidly and remains on for a preset time. At the end
of the preset time, the cooktop automatically returns
to the maximum power setting. This function can be
selected even during cooking.
Important: before selecting this function, make sure
the pot is positioned on the selected hotplate in order
to avoid any damage to the cooktop surface. The
stated performance values for this function are those
guaranteed for all glass ceramic cooktops. For this
function, place the pot on the selected hotplate and
turn the knob to
. To deselect, change the position
of the knob.
MULTIZONE
This is available on the front left and rear
left hotplates. This extends the heating area of the
cooktop in order to allow the use of large, oval or
rectangular pots or cooking receptacles. To select
this function: turn the knob to
and wait until
the residual heat indicator for the hotplate begins
to flash. To switch on the triple zone function (if
available), wait until the LED begins flashing quickly.
Select the power setting required by turning the knob
anticlockwise. The residual heat indicator remains on
to indicate that the cooktop is in use. To deselect, turn
the knob to
by turning the knob anticlockwise.
Please note: The multizone function can only be switched on
for the double and triple hotplates of the cooktop.
DAILY USE
