Kingston Technology KHX2133C9AD3W1K2/4GX Datasheet

Kingston Technology
Brand
Kingston Technology
Model
KHX2133C9AD3W1K2/4GX
Category
Memory modules
Type
Datasheet

Kingston Technology KHX2133C9AD3W1K2/4GX is a kit of two 2GB DDR3-2133MHz CL9 SDRAM memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Each module kit supports Intel ® XMP (Extreme Memory Profiles). Total kit capacity is 4GB. Each module kit has been tested to run at DDR3-2133MHz at a low latency timing of 9-11-9 at 1.65V. The SPDs are programmed to JEDEC standard latency DDR3-1333MHz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V.

The Kingston Technology KHX2133C9AD3W1K2/4GX is a

Kingston Technology KHX2133C9AD3W1K2/4GX is a kit of two 2GB DDR3-2133MHz CL9 SDRAM memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Each module kit supports Intel ® XMP (Extreme Memory Profiles). Total kit capacity is 4GB. Each module kit has been tested to run at DDR3-2133MHz at a low latency timing of 9-11-9 at 1.65V. The SPDs are programmed to JEDEC standard latency DDR3-1333MHz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V.

The Kingston Technology KHX2133C9AD3W1K2/4GX is a

Memory Module Specification
Document No. 4805610-001.A00
05/21/10
KHX2133C9AD3W1K2/4GX
4GB (2GB 256M x 64-Bit x 2 pcs.) DDR3-2133MHz
CL9 240-Pin DIMM Kit
Page 1
DESCRIPTION:
Kingston's KHX2133C9AD3W1K2/4GX is a kit of two 256M x 64-bit 2GB (2048MB) DDR3-2133MHz CL9 SDRAM
(Synchronous DRAM), water cooled, memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per
module. Each module kit supports Intel
®
XMP (Extreme Memory Profiles). Total kit capacity is 4GB. Each module kit
has been tested to run at DDR3-2133MHz at a low latency timing of 9-11-9 at 1.65V. The SPDs are programmed to
JEDEC standard latency DDR3-1333MHz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and
requires +1.5V. The JEDEC standard electrical and mechanical specifications are as follows:
FEATURES:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.88” (48.00mm) w/ heatsink, double sided component
PERFORMANCE:
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns
Row Active Time (tRASmin) 36ns (min.)
Power 1.800 W (operating per module)
UL Rating 94 V - 0
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C
TECHNOLOGY
ValueRAM
Document No. 4805610-001.A00 Page 2
MODULE DIMENSIONS:
Units: millimeters
30.00
18.80
15.80
11.00
8.00
0.00
133.35
0.00
54.70
TECHNO L O GY
48.00mm
1.88
8.70mm
0.342
MODULE WITH HEATSINK:
COOLING TUBE DIMENSIONS:
(units: millimeters)
1/4" (6.35mm) I.D. fluid hose recommended
  • Page 1 1
  • Page 2 2

Kingston Technology KHX2133C9AD3W1K2/4GX Datasheet

Kingston Technology
Brand
Kingston Technology
Model
KHX2133C9AD3W1K2/4GX
Category
Memory modules
Type
Datasheet

Kingston Technology KHX2133C9AD3W1K2/4GX is a kit of two 2GB DDR3-2133MHz CL9 SDRAM memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Each module kit supports Intel ® XMP (Extreme Memory Profiles). Total kit capacity is 4GB. Each module kit has been tested to run at DDR3-2133MHz at a low latency timing of 9-11-9 at 1.65V. The SPDs are programmed to JEDEC standard latency DDR3-1333MHz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V.

The Kingston Technology KHX2133C9AD3W1K2/4GX is a

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents