Page is loading ...
2
Copyright
Copyright 2004 by X-Micro Technology Corp., All rights reserved. No part of
this publication may be reproduced, transmitted, transcribed, stored in a
retrieval system, or translated into any language or computer language, in any
form or by any means, electronic, mechanical, magnetic, optical, chemical,
manual or otherwise, without the prior written permission of X-Micro
Technology Corp.
Disclaimer
X-Micro Technology Corp. makes no representations or warranties, either
expressed or implied, with respect to the contents hereof and specifically
disclaims any warranties, merchantability or fitness for any particular purpose.
Any software described in this manual is sold or licensed "as is". Should the
programs prove defective following their purchase, the buyer (and not this
company, its distributor, or its dealer) assumes the entire cost of all necessary
servicing, repair, and any incidental or consequential damages resulting from
any defect in the software. Further, X-Micro Technology Corp., reserves the
right to revise this publication and to make changes from time to time in the
contents hereof without obligation to notify any person of such revision or
change.
All brand and product names mentioned in this manual are trademarks and/or
registered trademarks of their respective holders.
3
Functions
USB- IF certificated, CE&FCC approved
Fully compatible with USB 2.0 Specification
Fully backward Compatible with USB1.1 specification
Support transfer rate of 480 Mbps
Support self-powered mode
Support hot plug & play
Compatible with PC windows 98SE/2000/ME/XP
Specification
Bus interface USB 2.0
Transfer rate 480 Mbps
Connectors 1 mini USB connector
Spin 4200rpm
HDD 9mm, 2.5inch 40/60/80GB
Buffer 2MB
Search Ave. 12ms
LED Flash active
Power USB self-powered
Dimension 146 x 75 x 14 mm Aluminum
Electrical +5V, 500mA Max.
Operating
requirements
Temperature from 0˚C to 55˚C
Relative humidity 20-80%
(Non-condensing)
Hardware Installation
In order to get the USB 2.0 performance, make sure to properly install the
USB 2.0 driver to your desktop computer or USB 2.0 driver to your
notebook.
Step 1.
Connect the USB 2.0 cable with data connector to your desktop computer
or notebook.
4
Step 2.
Connect the USB 2.0 cable power connector to your desktop computer or
notebook.
Step 3.
Connect the USB 2.0 cable mini connector to X-Micro Slim Portable HDD.
The LED will lit after the above steps are properly installed.
Now you can check your file manager for new external hard disk.
For Win 98 user, please insert CD into your CD-Rom, the driver will install
automatically. Follow the instruction on screen step by step.
Important Notice :
1. Warranty will overdue if the housing has been opened
2. Strong recommend that power USB connector should be
connected to system when the product on used.
3. Shock and vibration will damage HDD, try to avoid it!
www.x-micro.com
/