4002242-01
623 Square Trim Kit
INSTALLATION INSTRUCTIONS
Use with Valor Models 645CFV (534 Heater) & 1240BPK (1200 heater) only
The 623 square trim is intended to be used on Valor heaters models 534 tted with the 645 Clearview Front or 1200
tted with the 1240 Three-Sided Trim. Installation of the 623 does not affect clearances, framing dimensions, or
other specications listed in the heater installation manuals—see installation manual supplied with the heater.
Note: Backing or wall anchors may be required behind the wall nish at xing points to secure the trim to
the wall.
Installation
1. Install the heater as per installation
instructions supplied with the heater. Allow
for the height of the nished hearth.
2. Install the front kit following the instructions
packed with the kit.
3. Mark out the position of of the mounting
cleat and x the cleat to the wall. Use self-
drilling screws for mounting to 1200 heater.
4. Carefully center and locate the Square
trim to the cleat and heater, ensure the magnets
mounted at bottom of each leg make contact with
the heater front.
1200
Heater
534
Heater
1240 Three-
Sided Trim
645
Clearview
Front
623 Square
Trim
623 Square
Trim
Cleat
807 mm (31-3/4”)
1126 mm (44-3/8”)
875 mm (34-7/16”)
base line of installed heater
base line of
installed heater
Overview
Overview
Cleat
Trim
Rear view
center line of heater
© Copyright Miles Industries Ltd., 2010.
Designed and Manufactured by / for
Miles Industries Ltd.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
www.valorreplaces.com
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
Page is loading ...
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Valor 623ST Le manuel du propriétaire