Paradyne COMSPHERE 3610 Installation guide
- Type
- Installation guide
You have accessed an older version of a
Paradyne product document.
Paradyne is no longer a subsidiary of
AT&T. Any reference to AT&T Paradyne is
amended to read Paradyne Corporation.
13610-A2-GZ45-10 March 1996
3600 Hubbing Device Installation Instructions
Document Number 3610-A2-GZ45-10
March 1996
Overview
This document describes the pin assignments and
procedure for installing the 3600 Hubbing Device.
• The 3600 Hubbing Device is required to daisy
chain a Model 3610 Data Service Unit (DSU) onto
a Network Management System (NMS) control
channel (CC) or diagnostic channel (DC).
• The hubbing device plugs into a modular jack
located on the rear of the DSU and provides two
8-pin modular jacks for DC/CC connections.
Prior to installing a 3600 Hubbing Device, check the
hubbing device for damage. If there are signs of damage,
report this immediately to your shipping representative
and your AT&T Paradyne representative.
WARNING
This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with
the instruction manual, may cause
harmful interference to radio
communications. Operation of this
equipment in a residential area is likely
to cause harmful interference, in which
case, the user will be required to correct
the interference at his own expense.
The authority to operate this equipment
is conditioned by the requirement that no
modifications will be made to the
equipment unless the changes or
modifications are expressly approved by
AT&T Paradyne.
TO USERS OF DIGITAL APPARATUS IN
CANADA: The digital apparatus does not
exceed the Class A limits for radio noise
emissions from digital apparatus set out
in the radio interference regulations of
the Canadian Department of
Communications.
P
a
r
a
dyn
e
2 March 1996 3610-A2-GZ45-10
Hubbing Device Pin
Assignments
3000HUBBING DEVICE
MODEL #3000-F3-300
P
a
r
a
dyn
e
8-Pin
Modular
Jacks
6 Inches
Overall
4-Pin
Modular
Plug
496-13775-02
8
1
Pin
Numbers
8
1
CC IN/DC OUT
CC OUT/DC IN
CC IN/DC OUT
Hubbing Device
CC OUT/DC IN
4-Pin Modular Plug
The 4-pin modular plug on the 3600 Hubbing Device is
the DSU interface. Table 1 lists the pin numbers and
signal names.
Table 1
4-Pin Modular Plug Pin Assignments
Pin #
Signal Name Input/Output
1 +5 VDC Input
2 DCOSD/CCIRD Input
3 Signal Ground Ground
4 DCORD/CCISD Output
8-Pin Modular Jacks
Use the 8-pin modular jacks to connect the DSU to the
Network Management System, another 3600 Hubbing
Device, or a 3400 Hubbing Device. One jack supports CC
in and DC out. The other jack supports CC out and DC in.
Tables 2 and 3 list the pin numbers and signal names.
NOTE
The pin numbers on both
modular jacks are compatible
with the 3400 Hubbing Device.
Therefore, no additional adapter
is required when using the 3600
Hubbing Device and the 3400
Hubbing Device in the same
configuration.
Table 2
CC IN/DC OUT Jack Connector
Pin Assignments
Pin #
Signal Name
IN/
OUT
CC
IN
DC
OUT
1
–V Pass Through
— –V –V
2
DCOCTS/CCIRTS
IN RTS CTS
3
DCORTS/CCICTS
OUT CTS RTS
4
DCOSD/CCIRD
OUT RD SD
5
Signal Ground
— GND GND
6
DCORD/CCISD
IN SD RD
7
N/C
— N/C N/C
8
+V Pass Through
— +V +V
Table 3
CC OUT/DC IN Jack Connector
Pin Assignments
Pin #
Signal Name
IN/
OUT
CC
OUT
DC
IN
1
–V Pass Through
— –V –V
2 DCICTS/CCORTS OUT RTS CTS
3 DCIRTS/CCOCTS IN CTS RTS
4 DCISD/CCORD IN RD SD
5 Signal Ground — GND GND
6 DCIRD/CCOSD OUT SD RD
7 N/C — N/C N/C
8
+V Pass Through
— +V +V
33610-A2-GZ45-10 March 1996
Installing the 3600 Hubbing
Device
NOTE
When installing 3600 DSUs and
3400 Series or DATAPHONE II
modems on the same DC, install
the DSU ahead (upstream) of
the modems. This configuration
prevents the DSU from losing
contact if the modem loses
power.
Procedure
To connect the 3600 Hubbing Device to the DSU:
1. Configure the DSU for either CC or DC operation
using the Diagnostic Connection configuration
option as described in the COMSPHERE 3600
Series Data Service Units, Models 3610 and 3611,
User’s Guide, Document number 3610-A2-GB46.
2. Plug the hubbing device’s 4-pin modular plug into
the jack labeled CC/DC and located at the rear of
the DSU.
3. Plug one end of the M6BJ cable into the hubbing
device jack labeled CC IN/DC OUT.
4. Plug the opposite end of the M6BJ cable into the
appropriate 6700 or 6800 Series NMS jack.
495-14723
NMS Network
Connection
CC/DC
Hubbing
Device
To
NMS
POWER
LINE
BACKUP
CC/DC
V.35
CC IN/DC OUT
3000HUBBING DE
MODEL #3000-F3
P
a
r
a
dy
CC IN/DC OUT
CC OUT/DC IN
M6BJ
Cable
3000HUBBING DEVICE
MODEL #3000-F3-300
P
a
r
a
dyn
e
The hubbing device is now connected to the DSU and
may be used to set up your network configuration.
Refer to Figure 1 on the following page for a sample
NMS configuration.
Refer to the COMSPHERE 3600 Series Data Service
Units, Models 3610 and 3611, User’s Guide for additional
connection information and configurations.
4 March 1996 3610-A2-GZ45-10
Model
3610
DSU
Model
3610
DSU
Model
3610
DSU
3400
Series
Modem
3400
Series
Modem
871A
873A
6800
Series
NMS
3000
Series
Carrier
CC
IN
CC
IN
CC
OUT
CC
IN
CC
OUT
CC
IN
4000
Series
Intelligent
Communications
Carrier
Upstream
Downstream
Upstream Downstream
496-13777-01
DC
OUT
Tributary
Extended
Control
Control
Extended
Tributary
DC
IN
DC
OUT
DC
OUT
3600 Hubbing Device
3400 Hubbing Device
Note: All connections shown on this page use an M6BJ 6-conductor cord, unless otherwise noted.
CC
OUT
D8W
Cable
D8W
Cable
NMS
Adapter
NMS
Adapter
Figure 1. NMS Configuration Example Using Hubbing Devices
-
1
-
2
-
3
-
4
-
5
Paradyne COMSPHERE 3610 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Paradyne COMSPHERE 3610 Important information
-
Paradyne 3616 User manual
-
Paradyne COMSPHERE DualFlow 3615 User manual
-
-
-
Paradyne 3551 User manual
-
-
Paradyne COMSPHERE 3921Plus Installation guide
-
Paradyne COMSPHERE 3550 User manual
-
Paradyne COMSPHERE DualFlow 3615 Quick Reference Manual
