Omega FTB690 Series Owner's manual

Computer Assembly Kit for FTB690 Series Meter

M-4410B /0307

InstallatIon InstructIons

1. Your meter should be installed with the arrow pointed in the

direction of ﬂow. You can rotate the computer electronics

180 degrees before you install the computer.

2. Check that the batteries are secure in the back of the

computer.

3. Mount the computer on the turbine with the four screws at

the corners of the faceplate. Make sure the O-ring is fully

seated before tightening the screws.

4. Check meter accuracy before using. Make sure there is no air

in the system by starting the ﬂow until it runs steadily. Then

stop the ﬂow using a valve or nozzle.

5. Hold down DISPLAY button for three seconds to zero the

meter’s Batch Total. When zeroes appear, release the button.

6. Meter an exact known volume into an accurate container.

For best results, meter with one continuous full stream.

7. Check the readout. If the amount metered is accurate, ﬁeld

calibration is not necessary. If not, refer the Calibration

Section in your Owner’s Manual.

This Kit includes:

• Replacement Computer Assembly with Two Lithium

Batteries

• Four Screws

• One O-Ring

Use with Kits:

FTB691-CK

FTB692-CK

FTB693-CK

FTB694-CK

FTB695-CK