Gibson Pickup Wiring Diagram
P-94Rand P-94T
GREEN & BARE
TO GROUND
WHITE LEAD
BLACK LEAD
The P-94 pickup comes with two insulated lead wires plus a bare wire twisted
with a green lead (note: there may be a red wire included, this is a “dead” lead
which you may cut). Connect either the white or black lead wire to the volume
control and connect the other lead to ground. If you get a thin sound with both
pickups in operation, you may need to change the polarity of the pickup. Simply
reverse the lead wires to do this.
If you are using both the P-94T and P-94R together, use the black lead on one
position, and the white lead for the other. This will give you hum-cancelling
operation when both pickups are in use.
Gibson Pickup Wiring Diagram
Vintage Style Two Conductor Models
P-90
P-100
‘57 Classic
‘57 Classic Plus
Angus Young Sig.
BurstBucker
SHIELD TO
GROUND
TO VOLUME
POT OR
SELECTOR
SWITCH
Gibson Pickup Wiring Diagram
Four Conductor Models
(490R/490T, 498T, 496R, 500T, Tony Iommi Sig.)
Standard Humbucking Operation
Note:
If pickup is out of phase
with existing pickup,
reverse black and red leads
green & white
solder together & tape
black & shield to ground
red to controls
Coil Tap - Humbucking
Switching
Single Coil
SPDT ON / ON
MINI-TOGGLE
Humbucking
Red to Control
Black & shield
to ground
Series - Parallel Switching
Parallel
“Single Coil”
Sound
DPDT ON / ON
MINI-TOGGLE
Series
“Humbucking”
Sound
Red to Control
Shield to ground
-
1
-
2
-
3
Gibson 57 Classic Vintage BK Product information
- Type
- Product information
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Gibson Guitars 1550-07 GUS User manual
-
Fender 1 User manual
-
Fishman Fluence Classic Humbucker Pickup Installation guide
-
Roland GP-8 Owner's manual
-
Yamaha ERB070BP Datasheet
-
PRS Pickup Tremonti Treble Product information
-
-
-
-
