Retekess TA100 is a wireless audio transmission system designed for musical instruments and audio devices. With a 5.729~5.820GHz frequency range, it offers stable and clear sound transmission. Simply connect the transmitter to your instrument and the receiver to your amp or pedals. The devices will automatically pair when powered on, indicated by a solid orange light. If the orange light flashes, press and hold both the transmitter and receiver ID buttons for 5-7 seconds until the lights match and the orange indicators turn off. Enjoy the freedom of wireless audio with the Retekess TA100!
Retekess TA100 is a wireless audio transmission system designed for musical instruments and audio devices. With a 5.729~5.820GHz frequency range, it offers stable and clear sound transmission. Simply connect the transmitter to your instrument and the receiver to your amp or pedals. The devices will automatically pair when powered on, indicated by a solid orange light. If the orange light flashes, press and hold both the transmitter and receiver ID buttons for 5-7 seconds until the lights match and the orange indicators turn off. Enjoy the freedom of wireless audio with the Retekess TA100!
TRANSMITTER
TRANSMITTER
RECEIVER
RECEIVER
To Instrument
To Amp
NOTICE:
1. In case of failure paring, press Transmitter POWER button first (back to
factory preset), and then operate following step 2 above.
2. In case of unexpected influence happened to the wireless connection, just only press
Transmitter ID button to change to another channel, and the Receiver changes to the
same automatically.
3. ID indicators 4 colours - red, green, blue and purple refer to 4 different channels.
RF ENERGY EXPOSURE AND PRODUCT SAFETY GUIDE
Avoid Choking Hazard
ATTENTION!
WARNING
1. Press and hold POWER buttons on Transmitter and Receiver to turn On.
2. If that both ID indicators show a same colour and orange lights Off, which means that
Transmitter and Receiver are paired successfully and ready to use.
3. If that the orange indicator flashes, press and hold both Transmitter and Receiver ID
button for 5 - 7 seconds to turn the ID lights a same colour and orange indicators Off.
4. Connect the Transmitter to your instrument, and Receiver to your amps or pedals.
Play and enjoy the freedom!
TA100
Before using this radio, read this guide which contains important
operating instructions for safe usage and rf energy awareness and
control for compliance with applicable standards and regulations.
This radio uses electromagnetic energy in the radio frequency (RF) spectrum to provide
communications between two or more users over a distance. RF energy, which when
used improperly, can cause biological damage.
All Retekess radios are designed, manufactured, and tested to ensure they meet
government-established RF exposure levels. In addition, manufacturers also recommend
specific operating instructions to users of the radios. These instructions are important
because they inform users about RF energy exposure and provide simple procedures on
how to control it.
Please refer to the following websites for more information on what RF energy exposure
is and how to control your exposure to assure compliance with established RF exposure
limits: http://www.who.int/en/
Local Government Regulations
When radios are used as a consequence of employment, the Local Government
Regulations requires users to be fully aware of and able to control their exposure to meet
occupational requirements. Exposure awareness can be facilitated by the use of a product
label directing users to specific user awareness information. Your Retekess radio has a RF
Exposure Product Label. Also, your Retekess user manual, or separate safety booklet
includes information and operating instructions required to control your RF exposure and
to satisfy compliance requirements.
Radio License (if appropriate)
Governments keep the radios in classification, business radios operate on radio
frequencies that are regulated by the local radio management departments (FCC, ISED,
OFCOM, ANFR, BFTK, Bundesnetzagentur...).To transmit on these frequencies, you are
required to have a license issued by them. The detailed classification and the use of your
radios, please contact the local government radio management departments.
Use of this radio outside the country where it was intended to be distributed is subject to
government regulations and may be prohibited.
Unauthorized modification and adjustment
Changes or modifications not expressly approved by the party responsible for compliance
may void the user’s authority granted by the local government radio management
departments to operate this radio and should not be made. To comply with the correspond-
ing requirements, transmitter adjustments should be made only by or under the
supervision of a person certified as technically qualified to perform transmitter
maintenance and repairs in the private land mobile and fixed services as certified by an
organization representative of the user of those services.
Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by
the local government radio management departments equipment authorization for this
radio could violate the rules.
FCC Requirements:
• This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CE Requirements:
• (Simple EU declaration of conformity) Henan Eshow Electronic Commerce Co.,Ltd
declares that the radio equipment type is in compliance with the essential requirements and
other relevant provisions of RED Directive 2014/53/EU and the ROHS Directive 2011/65/EU
and the WEEE Directive 2012/19/EU; the full text of the EU declaration of conformity is
available at the following internet address: www.retekess.com.
• Disposal
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you
that in the European Union, all electrical and electronic products, batteries, and accumula-
tors (rechargeable batteries) must be taken to designated collection locations at the end of
their working life. Do not dispose of these products as unsorted municipal waste. Dispose of
them according to the laws in your area.
IC Requirements:
Licence-exempt radio apparatus
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Information
• DO NOT operate the radio without a proper antenna attached, as this may damage the
radio and may also cause you to exceed RF exposure limits. A proper antenna is the
antenna supplied with this radio by the manufacturer or an antenna specifically authorized
by the manufacturer for use with this radio, and the antenna gain shall not exceed the
specified gain by the manufacturer declared.
• DO NOT transmit for more than 50% of total radio use time, more than 50% of the time
can cause RF exposure compliance requirements to be exceeded.
• During transmissions, your radio generates RF energy that can possibly cause
interference with other devices or systems. To avoid such interference, turn off the radio in
areas where signs are posted to do so.
• The device complies with RF specifications when the device used at 5mm from your body.
Third-party belt-clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be avoided.
• DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation
such as hospitals, aircraft, and blasting sites.
Small Parts. Not for children under 3 years.
Protect your hearing:
• Use the lowest volume necessary to do your job.
• Turn up the volume only if you are in noisy surroundings.
• Turn down the volume before adding headset or earpiece.
• Limit the amount of time you use headsets or earpieces at high
volume.
• When using the radio without a headset or earpiece, do not place
the radio's speaker directly against your ear
• Use careful with the earphone maybe possible excessive sound
pressure from earphones and headphones can cause hearing loss
Note: Exposure to loud noises from any source for extended periods
of time may temporarily or permanently affect your hearing. The
louder the radio's volume, the less time is required before your
hearing could be affected. Hearing damage from loud noise is
sometimes undetectable at first and can have a cumulative effect.
Protect your hearing:
• This radio meets the RF exposure guidelines when used with the
Retekess accessories supplied or designated for the product. Use of
other accessories may not ensure compliance with the RF exposure
guidelines and may violate regulations.
• For a list of Retekess-approved accessories for your radio model,
visit the following website: http://www.Retekess.com
WARNING
Protect your hearing:
Antennas
• Do not use any portable radio that has a damaged antenna. If a
damaged antenna comes into contact with the skin when the radio is
in use, a minor burn can result.
Batteries (If appropriate)
• When the conductive material such as jewelry, keys or chains touch
exposed terminals of the batteries, may complete an electrical circuit
(short circuit the battery) and become hot to cause bodily injury such
as burns. Exercise care in handling any battery, particularly when
placing it inside a pocket, purse or other container with metal objects
Long transmission
• When the transceiver is used for long transmissions, the radiator
and chassis will become hot.
WARNING
Protect your hearing:
Forbid
• Do not use charger outdoors or in moist environments, use only in dry
locations/conditions.
• Do not disassemble the charger, that may result in risk of electrical
shock or fire.
• Do not operate the charger if it has been broken or damaged in any
way.
• Do not place a portable radio in the area over an air bag or in the air
bag deployment area. The radio may be propelled with great force and
cause serious injury to occupants of the vehicle when the air bag
inflates.
To reduce risk
• Pull by the plug rather than the cord when disconnecting the charger.
• Unplug the charger from the AC outlet before attempting any
maintenance or cleaning.
• Contact Retekess for assistance regarding repairs and service.
• The adapter shall be installed near the equipment and shall be easily
accessible
• Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
• Adapter shall be installed near the equipment and shall be easily
accessible.
• The plug considered as disconnect device of adapter.
• The operating temperature of the EUT can’t exceed the specified
range.
WARNING
Henan Eshow Electronic Commerce Co., Ltd
Add: 7/F, Sanjiang Building, No.170 Nanyang Road, Huiji District,
Zhengzhou, Henan, China
EU Importer: Germany Retevis Technology GmbH
Address: Uetzenacker 29,38176 wendeburg
Facebook: facebook.com/RetekessWirelessSystem
E-mail: [email protected]
Web: www.retekess.com
MADE IN CHINA
Model Number:
Serial Number:
Purchasing Date:
Dealer: Telephone:
User’s Name: Telephone:
Country: Address:
Post Code: Email:
Remarks:
1.This guarantee card should be kept by the user, no replacement if lost.
2.Most new products carry a two-year manufacturer’s warranty from the date of
purchase.
3.The user can get warranty and after-sales service as below:
Contact the seller where you buy.
Products Repaired by Our Local Repair Center
4.For warranty service, you will need to provide a receipt proof of purchase from the
actual seller for verification
Exclusions from Warranty Coverage:
1.To any product damaged by accident.
2.In the event of misuse or abuse of the product or as a result of unauthorized
alterations or repairs.
3.If the serial number has been altered, defaced, or removed.
Guarantee
IDPOWER
1
2 3 4 65
Transmitter (black color)
1. 6.35mm gauge audio connector,
connecting to instruments or other
deviceswith same gauge audio
output jack.
2. Indicator (orange)
3. Channel and power indicator
4. Power button
5. ID button
6. Micro USB power recharging jack
Receiver (white color)
1. Audio output connector, connecting to
amp or any other products with same
gauge audio input jack. (all the other
parts and functions are the same as
Transmitter).
Power indicator ON
Power indicator flashes slowly
Power indicator flashes rapidly
Power indicator flashes in 5 seconds, and automatically turns off
Pairing
Paired
Orange light flashes
Orange light off
TRANSMITTER
TRANSMITTER
RECEIVER
RECEIVER
5.729~5.820GHz
TA100
TA100 TA100
TA100 Transmitter
TA100 Receiver
TA100
-
1
Retekess TA100 is a wireless audio transmission system designed for musical instruments and audio devices. With a 5.729~5.820GHz frequency range, it offers stable and clear sound transmission. Simply connect the transmitter to your instrument and the receiver to your amp or pedals. The devices will automatically pair when powered on, indicated by a solid orange light. If the orange light flashes, press and hold both the transmitter and receiver ID buttons for 5-7 seconds until the lights match and the orange indicators turn off. Enjoy the freedom of wireless audio with the Retekess TA100!
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
