or when not in use.
G
G
R
R
R
S
R
-
will
If the refrigerator is not leveled during installation, the doors may not close or seal properly, causing cooling,
frost, or moisture problems. It’s very important for the refrigerator to be level in order to function property.
Place refrigerator approximately 5 inches from the wall to ensure proper
airflow to the compressor. Do not place refrigerator near any heat sources such as a heater or stove as it will put
a strain on the compressor.
an outlet
Ice cream and popsicles
refrigerator's
5
dial to
OPERATION (CONTINUED)
REVERSING THE DOOR POSITION
Caution: To avoid injury to yourself and/or property, we recommend someone assist you during the door reversal process.
2
•Ensure the appliance is unplugged and empty.
•Adjust the two leveling feet to their highest position.
•We recommend you have someone to assist you.
Tools required
•Phillips head screwdriver
•Flathead screwdriver
NOTE:
To take the door off it is necessary to tilt the appliance
on
backward. You should rest the appliance something solid
e.g. a chair just below the top panel so you can access the
DO NOT lay the appliance completely flat as this may
damage the coolant system.
43
Plastic cover
Remove the plastic cover from door hinge first.
Then unscrew the two screws from top braket and
replace on the other side.
1
bottom of the refrigerator.
Start by removing the bracket from the bottom of the
refrigerator. Unscrew the two screws from the
bottom bracket. Remove the foot from opposite side.
Self-Tapping Screws/Bottom Bracket/Foot
Slide the door down, away from the hinge pin located
on the top of the door.
6
7
To install the bracket on the top left side of the
appliance, screw the two screws through the bracket
and into the top of the appliance. Slide the door back
on to the top hinge. Ensure the door is face up.
Replace the plastic cover on the top bracket by
pressing down until it clicks into position.
leveling
Replace the foot on the other side.
26.9
8
TROUBLESHOOTING GUIDE
thermostat control dial
The thermostat control dial is set too cold. Adjust the setting towards 1.
Food is stored too close to the back of the refrigerator wall. Move food towards
the front of the shelves.
300
1.5
90
60115
The thermostat control dial is set too warm. Adjust the setting towards 6.
0
9
2.8 CUBIC FT. COMPACT REFRIGERATOR
:CR280-08062010-01
/