Biggies DC-SEV-36 Installation guide

Brand: Biggies

Model: DC-SEV-36

Type: Installation guide

APPLICATION INSTRUCTIONS

Stickie Dry-Erase

Biggies Wall Stickies will adhere to any smooth, dry surface including walls, windows,

doors, and more. The best surfaces are smooth, even, not textured, and non-porous. These

include painted walls, glass, finished wood, and metal. Paint and Primer should be

allowed to cure for up to one month before Wall Stickies are applied. Adhesion on

uneven, rough, porous or dirty/greasy surfaces may not be strong and edges could curl.

SPECIAL TIPS FOR BIGGIES WALL STICKIES

©Biggies, Incorporated 2019

Go to www.getBiggies.com

to see all Biggies products

STEP 1: SELECT

Once you have chosen the area for your Stickie Dry-Erase Sheet, plan for the center

of the sheet to be at eye level or a little below. Measure down from the ceiling in

multiple places with a pencil and see if this makes the best position for the top line

of your Dry-Erase Sheet in this particular room. Mark the wall lightly in several

spots to give you a visual target for placement.

STEP 2: PREP (VERY IMPORTANT)

Wipe the wall so it is FREE OF DUST with a rag or paper towel. If the wall is

greasy, wash the wall with an appropriate wall cleaner and dry the wall completely.

STEP 3: PEEL

After 20 minutes at room temperate FLIP the Dry-Erase Sheet over with the

BACKING FACING UP carefully, peel away & fold over the backing liner 4-5 inches

to expose the adhesive at the TOP EDGE and being careful to prevent the adhesive

surface from touching each other. Make sure the Dry-Erase Sheets do not crease.

Using 2 people when applying large r sheets is strongly recommended.

STEP 4: PLACE

Start applying one side of the Dry-Erase Sheet to the wall just beneath the pencil

marks you made in STEP 1. Firmly press the TOP EDGE of the entire 4-5 inches

onto the wall surface with a paper towel. Once in place start pulling the backing

liner down gradually using TWO hands. Wipe from the center out and be sure to

remove any air bubbles, if air bubbles occur peel up and re-smooth. When appling

multiple sheets together, overlap Dry-Erase Sheets 1/2 inch and press down tightly

on ALL overlaps and ALL edges.

Stickie Dry-Erase Sheets works best with newer EXPO

LOW ODOR dry-erase markers.

DO NOT use wet erase or permanent markers, always store markers lying horizontal.

Allow ALL Dry-Erase Pens to dry for at least 10 SECONDS before erasing.

Please READ ALL THE DIRECTIONS before appling Dry-Erase Sheets, if product has a curl,

roll out CAREFULLY with DRY-ERASE FACING UP, and anchor the corners with something

heavy for 20 minutes at room temperate, this will make it easier for installation.

For Video Instructions on installation, please go to

www.YOUTUBE.com and type in Biggies Dry Erase Sheet

Biggies DC-SEV-36 Installation guide

Biggies DC-SEV-36 Installation guide

Biggies DC-SEV-36 Installation guide

Related papers

Other documents