Water Creation F5-0010-02-AL Installation guide

Brand
Water Creation
Model
F5-0010-02-AL
Category
Sanitary ware
Type
Installation guide
MODEL: F5-0010
A) FAUCET INSTALLATION
1) Set the faucet in place, insert the inlet shanks through the sink holes
and press down.
2) Assemble the washers and locknuts on the inlet shanks, then tighten the
lock nut with wrench. Do not over tighten.
3) Set the sprayer holder in place, insert the shank through sink hole.
4) Assemble the washer and locknut on the shank, then tighten the lock nut
with wrench. Do not over tighten.
BEFORE YOU BEGIN
1) Shut off water supply.
2) Carefully inspect waste and supply tubing for signs of damage.
3) Replace waste or supply tubing if necessary
B) SPRAYER INSTALLATION
1) Hand tighten the sprayer with hose together.
2) Insert the hose through the sprayer holder under to sink.
3) Connect the hose to faucet inlet and tighten with wrench.
Do not over tighten.
TOOLS AND MATERIALS
FAUCET INSTALLATION GUIDE
Basin Wrench
Adjustable wrench
Teflon Tape
Pipe Wrench
Screwdriver
Flexible Water
Supply Line
MODEL: F5-0010
C) SUPPLY CONNECTION
1) Connect hoses (not included) to angle stops.
2) Tighten all connections.
3) Flush out water for two minutes before connect hose to faucet shank
D) FINAL INSPECTION
1) Ensure all connections are tightened properly.
2) Turn on main water supply.
3) Turn on and off cold and hot water respectively.
4) Turn on both hot and cold water and turn off. Check for leaks.
5) Remove the aerator cap and aerator. Check for debris. Clean if necessary .
6) Reinstall aerator.
  • Page 1 1
  • Page 2 2

Water Creation F5-0010-02-AL Installation guide

Brand
Water Creation
Model
F5-0010-02-AL
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents