VECLESUS VMW Installation guide

Brand
VECLESUS
Model
VMW
Type
Installation guide
1
1
2
3
① ②
Install short antenna
to the monitor
Install another short antenna to the
backup camera
③
Install the power cord
④
Pairing Button
This is for matching the monitor and the camera. They
were already paired before leaving the factory. You
don't need to configure them again.
Tips: If there is no image on display when the system is
powered on, try pressing this button multiple times to
pair the camera to the monitor.
Install sunshade to the monitor
⑤
2
⑥
Long Antenna
This is a spare antenna.
If you use this system on long vehicle and the signal is
not stable during driving, you can use it to extend the
antenna on the outside of the driving room.
⑦
Cigarette Lighter Power Cord
This is a second way to connect monitor to the power
source.
⑧
Power Line
Red Wire(Positive Pole)
This wire needs to be connected to +12-24 V power supply.
Many of the lines in the center console are accessible. You
should use a multimeter to test if the voltage meets the
requirement.
Black Wire(Negative Pole)
The GND wire needs to be connected to the negative pole.
Green Wire(Reversing Line)
Just as its name implies, it needs to be connected to the
reverse power such as reversing light, reverse gear power
or any other wires which can get power only reversing.
Thank you for choosing our products, If you have any other
questions, Please feel free to contact us!
Here is our website: www.veclesusclub.com
Installation Video：
3
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

VECLESUS VMW Installation guide

Brand
VECLESUS
Model
VMW
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents